期刊文献+

齿轮时变系统的强迫振动 被引量:5

Forced Vibration of Gear System with Time-varying Mesh Stiffness
下载PDF
导出
摘要 建立了考虑齿轮时变啮合刚度时的二级齿轮系统的动力学模型,用A算符方法推导出了系统的近似解析解,研究了系统对时变啮合刚度、扭矩波动及齿轮误差激励的响应。计算结果表明,A算符方法克服了谐波平衡法的缺陷,可靠性更高;系统响应的频率成分不仅与啮合频率和激励频率有关,还与其组合形式有关;即使激励频率远大于派生系统的固有频率,在实际的物理系统中,由于时变啮合刚度的影响,也可能出现主共振、谐共振和组合共振。 Dynamic model of two-stage gear system with time-varying mesh stiffness was established. Approximate analytic solution of the system was developed by means of A-operator method (AOM). It was used to investigate the response to time-varying mesh stiffness, torque fluctuation and errors of gear pair. It is shown that A-operator method (AOM) overcomes the filter defaults of harmonic balance method. Therefore it has more reliable numeric results. When the system is inspired by time-varying mesh stiffness, torque fluctuation and errors of gear pair, the frequency components of response are related to the inspiring frequency, and mesh frequency, and to their combined type. Even if inspiring frequency is far from frequency of the derived system, first harmonic, super harmonic and combined harmonic resonance may take place respectively in the normal speed range of an actual gear system, because of time-varying mesh stiffness.
出处 《中国机械工程》 EI CAS CSCD 北大核心 2005年第8期723-728,共6页 China Mechanical Engineering
基金 上海市高等学校科学技术发展基金资助项目(04OB03) 陕西省自然科学基金资助项目(2003E202)
关键词 A算符方法 参数振动 时变啮合刚度 齿轮啮合误差 扭矩波动 A-operator method parameter vibration time-varying mesh stiffness mesh errors of gear pair torque fluctuation
  • 引文网络
  • 相关文献

参考文献7

  • 1方锦清,姚伟光.逆算符方法求解非线性动力学方程及其一些应用实例[J].物理学报,1993,42(9):1375-1384. 被引量:30
  • 2Kubo A, Kiyono S. Vibrational Excitation of Cylindrical Involute Gears Due to Tooth form Error. Bulletin of JSME, 1980, 23(183): 1536~1543.
  • 3Umezawa K,Sato T. Influence of Gear Errors on Rotational Vibration of Power Transmission Spur Gears (3rd Report, Accumulative Pitch Error). Bulletin of JSME, 1985, 28(246): 3018~3024.
  • 4Maatar M, Velex P. Quasi-static and Dynamic Analysis of Narrow-faced Helical Gears with Profile and Lead Modification. ASME, Journal of Mechanical Design, 1991,119(10):474~480.
  • 5Adomian G. Solution of Coupled Nonlinear Partial Differential Equations by Decomposition. Computer Math. Applic., 1996, 31(6): 117~120.
  • 6Cai Y. Simulation on the Rotational Vibration of Helical Gears in Consideration of the Tooth Separation Phenomenon (A New Stiffness Function of Helical Involute Tooth Pair). ASME, Journal of Mechanical Design, 1995, 117(9): 460~468.
  • 7李华.[D].西安:西北工业大学,2002.

二级参考文献3

  • 1方锦清,1992年
  • 2方锦清,1992年
  • 3陈之江,REDUCE语言简明教程,1990年

共引文献29

同被引文献51

引证文献5

二级引证文献20

相关主题

;
使用帮助 返回顶部