期刊文献+

变形轴中心孔最佳位置的确定

Calculation of the Center Holes' Optimum Position of Deformed Shafts
下载PDF
导出
摘要 以往生产中只能凭直观或用外圆打表测量方法来确定变形轴中心孔最佳位置,这既不方便又不准确.经分析与计算,得出变形轴中心孔最佳位置为0.35L. In the past production, the center holes' optimum position of the deformed shafts could only be determined by means of estimation or instruments. Both of the methods are neither convenient nor accurate. Through some analysis and deduction, the calculating formula of the optimum position of the center holes has turned out as follows: P=0.35L.
作者 王润琪
出处 《中南林学院学报》 CSCD 1996年第3期89-91,共3页 Journal of Central South Forestry University
关键词 机械加工 变形轴 中心孔 定位 machining deformed shafts center holes optimum axial supporting position
  • 引文网络
  • 相关文献

参考文献4

  • 1宾鸿赞,机械制造工艺学,1990年
  • 2王先逵,机械制造工艺学,1989年
  • 3王宝玺,汽车拖拉机制造工艺学,1989年
  • 4团体著者,机械制造工艺学,1980年
;
使用帮助 返回顶部