摘要
本文分析了200.37.208工件化学热处理失圆度变形的原因,在IPSEN多用炉上用最合适的办法,在成本最低的条件下使这只工件的失圆度变形最小,并控制在合适的范围内,基本达到了攻关的目标。
This paper analyses the reason of distortion about the part 200.37. 208 prucessed in the all - purpose furnace from IPSEN by chemical heat treatment. The part is controlled to the smallest distortion in the right scale at the lowest cost by the best method. We achieved essentially the aim of item.
出处
《热处理技术与装备》
2008年第3期63-65,共3页
Heat Treatment Technology and Equipment
关键词
内齿圈
变形
碳氮共渗
多用炉
inner gear ring
distortion
earbonitriding
all-purpose furnace
