摘要
针对传统光学联合变换相关器只能探测到整数像素的位移矢量,提出用双三次样条插值方法提高联合变换光相关器探测位移矢量精度到亚像素.用光学联合变换相关器探测2幅图像的整数像素位移,取峰值整数坐标的5×5邻域,用双三次样条插值对此邻域进行二元曲面拟合,对曲面求导得到亚像素位移矢量,再用拟合法来复原图像.对比采样精度分别为0.01、0.1像素时的稳像效果,结果表明,两者峰值信噪比相差不大,但采样精度为0.1像素时,所花时间更能满足稳像实时性的要求.基于双三次样条插值的光学联合变换相关器探测精度达到0.1像素,峰值信噪比得到了较大提高.
For joint transform correlator (JTC) can only detect motion vector in integral pixel,a method using bicubic spline interpolation to increase detection accuracy to sub-pixel is proposed.First the integral pixel motion vector between two images was detected by JTC,and then a 5×5 area around peak value coordinates were selected.A dualistic surface was acquired by using bicubic spline interpolation.Through differentiating the dualistic surface,motion vector was achieved.Then the pictures were recovered by fitting.Moreover,the effects of stabilization of sampling accuracy in 0.01 pixels and 0.1 pixels were contrasted.Experimental results show that the differences of PSNR(peak signal-noise rate) between them are not significant.But when sampling rate is 0.1 pixel,it satisfies the stabilization's need for real-time.Motion detection by JTC based on bicubic spline interpolation rises to 0.1 pixels.PSNR has been increased.
出处
《浙江大学学报(工学版)》
EI
CAS
CSCD
北大核心
2010年第11期2198-2202,共5页
Journal of Zhejiang University:Engineering Science
基金
国家"973"重点基础研究发展计划资助项目(2009CB724002)
国家"863"高技术研究发展计划资助项目(2007AA12Z150)
关键词
图像处理
稳像
双三次样条插值
光学联合变换相关器
像移
image processing
image stabilization
bicubic spline interpolation
joint transform correlator(JTC)
motion vector