期刊文献+

低枪位下氧枪射流对熔池作用的冷态实验研究 被引量:2

Hydrodynamics model experiment study on impact of top blow jet on bath under low lance level
下载PDF
导出
摘要 采用水力学模型进行了低枪位下顶吹射流对熔池作用的冷态实验,研究了枪位、气体流量、氧枪喷头类型等因素对冲击深度、喷溅量和熔池混匀时间等的影响。实验结果发现,喷孔倾角增大时,射流冲击深度减小,熔池喷溅量较少,混匀时间相对较短。氧枪喷孔倾角为13°和17°时,其最小混匀时间对应枪位为60mm,冲击深度比为32%~50%;而氧枪喷孔倾角为24°时,其最小混匀时间对应枪位为90mm,冲击深度比为21%~27%。 The effect of the lance level,the gas flow rate and the type of the lance nozzle on the pool impact depth,splash amount and mixing time were investigated by hydrodynamics model.The results show that the impact depth is shallower,the pool splash amount is less and the mixing time is shorter when the holes inclined angle is larger.The minimum mixing time appeared when the lance level was 60mm,and the ratio of the impact depth and pool depth was 32%~50% with the inclined angle of hole is 13°or 17°.The minimum mixing time appeared when the top lance height is 90mm and the ratio of the impact depth is 21%~27% with the inclined angle of hole is 24°.
出处 《冶金能源》 2011年第2期13-17,共5页 Energy For Metallurgical Industry
关键词 氧气顶吹转炉 水力学模型 枪位 喷溅量 混匀时间 BOF hydrodynamics model lance level splash amount mixing time
  • 相关文献

参考文献5

二级参考文献12

共引文献42

同被引文献35

  • 1舒宏富,张建平,宋超,邹宗树.RH-MFB传质特性的物理模拟研究[J].炼钢,2005,21(6):37-40. 被引量:3
  • 2刘竹林,高泽平,贺志宏.300t转炉水力模型实验研究[J].特殊钢,2007,28(2):16-18. 被引量:12
  • 3包丽明,刘坤,吕国成,杨晶晶.转炉氧枪顶吹工艺的水力学模拟[J].特殊钢,2007,28(5):13-15. 被引量:15
  • 4Price D. Process engineering of pyrometallurgy [M]. London: 1974: 8-15.
  • 5Dogan N, Brooks G A, Rhamdhani M A. Comprehensive model of oxygen steel making part 1: model development and validation [J]. The Iron and Steel Institute of Japan International, 2011, 51(7) : 1086-1092.
  • 6Dogan N, Brooks G A, Rhamdhani M A. Comprehensive model of oxygen steel making part 3: decarburization in impact zone [J]. The Iron and Steel Institute of Japan International, 2011, 51(7). 1102-1109.
  • 7Asahara N, Naito K, Kitagawa I, et al. Fundamental study on interaction between top blown jet and liquid bath [J]. Steel Research International, 2011, 82(5): 587-594.
  • 8Banks R B, Chandrasekhara D V. Experimental investigation of the penetration of a high velocity gas jet through a liquid surface [J]. Journal of Fluid Mech, 1963, 15(1): 13-34.
  • 9Qian F, Mutharasan R, Farouk B. Studies of interface deformations in single- and multi-layered liquid baths due to an impinging gas jet . Metallurgical and Materials Transactions B, 1996, 27(6) : 911-920.
  • 10Hwang H Y, Irons G A. A water model study of impinging gas jets on liquid surfaces [J]. Metallurgical and Materials Transactions B, 2012, 43(2). 302-315.

引证文献2

二级引证文献6

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部