期刊文献+

基于Moldflow的汽车外饰件注射成型模拟与成型缺陷分析 被引量:5

Simulation of Injection Molding and Analysis of Molding Defect for Automotive Exterior Parts Based on Moldflow
下载PDF
导出
摘要 以汽车外饰件前风挡下装饰板为研究对象,利用Moldflow软件,对其注射成型过程进行模拟,针对分析结果中预测可能出现的成型缺陷,提出相应的优化措施。最后将结果应用于该装饰板的模具型腔设计。结果表明,Moldflow在设计阶段可以找出产品可能出现的缺陷,提高一次试模成功率,从而降低生产成本,提高生产效率。 Automotive exterior trim panel under the front windscreen was studied, and Moldflow software was used to simulate the injection molding process for it. Optimization measures were proposed for the possible formation of defects. Finally, the results were applied to the mold cavity design. It was verified that Moldflow could find future potential defects of the products in the designing stage. It could reduce the number of trial and the production cycle, thus reduce production costs and increase productivity.
出处 《中国塑料》 CAS CSCD 北大核心 2012年第4期106-109,共4页 China Plastics
关键词 MOLDFLOW 外饰件 注射成型 缺陷 Moldflow exterior part injection molding defect
  • 引文网络
  • 相关文献

参考文献4

二级参考文献11

共引文献39

同被引文献48

引证文献5

二级引证文献26

;
使用帮助 返回顶部