期刊文献+

Preparation and Characterization of Andalusite Ceramic Used for Solar Thermal Power Generation 被引量:1

Preparation and Characterization of Andalusite Ceramic Used for Solar Thermal Power Generation
下载PDF
导出
摘要 High-temperature thermal storage material is one of the critical materials of solar thermal power generation system. Andalusite, kaolin, talc, γ-Al2O3 and partially stabilized zireonia were used as the raw materials, and in-situ synthesis of cordierite was adopted to fabricate thermal storage material for solar thermal power generation via pressureless sintering. The phase compositions, microstructures and thermal shock resistances of the sintered samples were analyzed by XRD, SEM and EDS, and the corresponding mechanical properties were measured. The results show that the major phases of the samples are mullite and zirconium silicate, and the pores distribute uniformly. After being sintered at 1 460℃C, A4 sample exhibits a better mechanical performance and thermal shock resistance, its loss rate of bending strength after 30 cycles thermal shock is 3.04%, the bulk density and bending strength are 2.86 g.cm^-3 and 139.66 MPa, respectively. The better thermal shock resistance of the sample is closely related to the effect of zirconium silicate, such as its uniform distribution, nested growth with mullite, low thermal expansion coefficient, high thermal conductivity, etc. This ceramic can be widely used as one of potential thermal storage materials of solar thermal power generation system. High-temperature thermal storage material is one of the critical materials of solar thermal power generation system. Andalusite, kaolin, talc, γ-Al2O3 and partially stabilized zireonia were used as the raw materials, and in-situ synthesis of cordierite was adopted to fabricate thermal storage material for solar thermal power generation via pressureless sintering. The phase compositions, microstructures and thermal shock resistances of the sintered samples were analyzed by XRD, SEM and EDS, and the corresponding mechanical properties were measured. The results show that the major phases of the samples are mullite and zirconium silicate, and the pores distribute uniformly. After being sintered at 1 460℃C, A4 sample exhibits a better mechanical performance and thermal shock resistance, its loss rate of bending strength after 30 cycles thermal shock is 3.04%, the bulk density and bending strength are 2.86 g.cm^-3 and 139.66 MPa, respectively. The better thermal shock resistance of the sample is closely related to the effect of zirconium silicate, such as its uniform distribution, nested growth with mullite, low thermal expansion coefficient, high thermal conductivity, etc. This ceramic can be widely used as one of potential thermal storage materials of solar thermal power generation system.
出处 《Journal of Wuhan University of Technology(Materials Science)》 SCIE EI CAS 2014年第3期422-427,共6页 武汉理工大学学报(材料科学英文版)
基金 Funded by the Major State Basic Research Development Program of China(973 Program)(No.2010CB227105) Self-determined and Innovative Research Funds of WUT(No.44420520001)
关键词 andalnsite MULLITE thermal storage ceramics thermal shock resistance solar thermal power generation andalnsite mullite thermal storage ceramics thermal shock resistance solar thermal power generation
  • 引文网络
  • 相关文献

参考文献8

二级参考文献40

共引文献55

同被引文献9

引证文献1

二级引证文献1

;
使用帮助 返回顶部