期刊文献+

PC热带钢连轧机弯辊力和交叉角的控制决策 被引量:5

Control Strategy of Bending Force and Cross Anglefor PC Hot Strip Mill
下载PDF
导出
摘要 提出了 PC热带钢连轧机板凸度和板形的控制原则 ,确定了弯辊力与交叉角配合的控制策略 ,并利用所建立的交叉角优化计算模型和实测数据对上海宝山钢铁 (集团 )公司 15 80 PC热连轧机现场轧制的 5块带钢进行了成品板凸度、交叉角及弯辊力最佳设定的计算。计算结果表明 ,成品板凸度的计算值与实测值吻合很好 ;交叉角优化后 ,在仍保持板形良好的情况下 ,成品板的凸度较优化前有不同程度的减小 。 The control principle for profile and flatness of PC hot strip mills was put forward, and the control strategy of bending force and cross angle was established. Using the established cross angle optimal calculation model and measured data, the calculation of profile and optimal setup of bending force and cross angle for five steel strips on the spot of 1580 hot strip mill were conducted. The calculation results showed that the calculation values fit well with the measured one. Under the circumstance of keeping good flatness, the crown of the rolled strip was reduced to some extent compared with non optimal one, which shows the effectiveness of optimal model.
出处 《钢铁研究学报》 CAS CSCD 北大核心 2001年第2期24-27,共4页 Journal of Iron and Steel Research
基金 原机械工业部九五攻关项目 !(95 -5 2 8-0 1-0 1-0 1E)
关键词 热连轧机 弯辊力 交叉角 控制决策 带钢轧机 板凸度 板形控制 PC hot strip mill bending force cross angle control strategy
  • 引文网络
  • 相关文献

参考文献7

二级参考文献8

  • 1刘宏民,郜时建.热带钢连轧机板形设定控制数学模型[J].钢铁,1996,31(10):30-34. 被引量:15
  • 2连家创,板厚板形控制,1996年,4页
  • 3包雪松(译),数值方法,1990年,6页
  • 4连家创,Proceedings of First International Conference on Steel Rolling (Vol.2). Tokyo: The Iron and Steel Institute of Japan,1980年,713页
  • 5连家创,东北重型机械学院学报,1980年,4卷,1期,1页
  • 6连家创,板厚板形控制,1996年,75页
  • 7王国栋,板形控制和板形理论,1986年,386页
  • 8Lian Jiachuang,Proc 2nd Int Conf Difference Equations,Veszprem,Hungary,August 7- 11,1995,1980年,2卷,713页

共引文献53

同被引文献14

引证文献5

二级引证文献10

相关主题

;
使用帮助 返回顶部