摘要
FANUC数控系统利用FSSB将CNC与伺服放大器及分离型检测器进行连接,并通过FSSB参数设定来建立主控器与从控器之间的对应关系。从FSSB常见报警着手,基于半闭环和全闭环系统,详细介绍了FSSB网络配置方法。最后,以实例说明FSSB网络配置方法并进行了实践验证。
FANUC CNC system uses FSSB to connect CNC with servo amplifier and separation detector,and establishes the corresponding relationship between master controller and slave controller by setting FSSB parameters.Starting from the common FSSB alarms,based on the semi-closed loop and fully closed loop systems,the FSSB network configuration method is introduced in detail.Finally,an example is used to illustrate the FSSB network configuration and verify it in practice.
作者
雷楠南
LEI Nan-nan(Automotive College,Sanmenxia Polytechnic,Sanmenxia 472000,China)
出处
《机械工程与自动化》
2021年第3期53-55,共3页
Mechanical Engineering & Automation
基金
河南省三门峡市科技攻关项目(2019010118)。
