摘要
酸洗加负压加热预处理可以明显地改善非晶态Ni_(63)Zr_(37)合金条带的乙炔加氢反应催化活性,采用俄歇电子能谱(AES),X射线光电子能谱(XPS),并结合氩离子溅射对预处理前后合金条带的表层成分深度分布及化学状态进行了研究。采用XRD及BET方法对预处理前后条带的结构及比表面积进行了测定。结果表明,由于Zr的选择氧化,非晶条带原始表面被一层锆的氧化物覆盖。预处理后,条带比表面积从0.05 m^2/g增加到了15.41/m^2/g,条带表面Ni与Zr原子比从预处理前的Ni_(<1)Zr_(>99)增加到了Ni_(57)Zr_(43),随合金浓度变化,金属Ni的Ni2_(p3/2)结合能发生变化,并且随Zr浓度降低,Ni2_(p3/2)结合能降低。
Amorphous Ni_(63)Zr_(37) alloy ribbon surface exhibited high catalytic activity for hydrogenation of ethyne to ethylene, when the alloy ribbon surface was pretreated with a dilute acid solution and heated under negative atmospheric pressure successively. The elemental composititon and chemical characteristics as a function of depth below the surface has been determined by means of Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS) combined with the use of argon ion bombardment. The ribbon structure and surface area were estimated by XRD and BET method. The experimental results show that raw amorphous alloy surface was covered by a thin layer of oxides of zirconium. After pretreatment, the surface area was changed from 0.05 m^2/g to 15.41 m^2/g, elemental Ni to Zr ratio on the ribbon surface was changed from Ne_(≤1) Zr_(≥99) to Ni_(57) Zr_(43). The decrease of surface zirconium (?)oncentration reduces the Ni_2p_(3/2) binding energy of surface nickel.
出处
《化学学报》
SCIE
CAS
CSCD
北大核心
1992年第6期549-554,共6页
Acta Chimica Sinica
基金
河南省自然科学基金