期刊文献+

牙轮钻头滑动轴承的接触有限元优化设计 被引量:11

Optimal Design of Sliding Bearings for Roller Bit with Contact FEA
下载PDF
导出
摘要 以牙爪大轴颈和小轴颈的鼓形度为设计变量,以接触有限元分析的峰值接触压力为目标函数,以牙爪轴颈的体积不超过给定值作为约束条件,用接触有限元方法建立了牙轮钻头滑动轴承的优化设计模型。利用ANSYS软件进行接触有限元优化设计,优化结果表明:最优方案的峰值接触压力相对理想模型(无鼓形度)降低了34.6%,并且接触压力分布合理。 Taking the drum degree of the big journal and small journal of SBFRB as design variables, the peak contact pressure as objective function and that the journal volume should less than a given value as constraint function,this paper established the model of optimal design for SBFRB with contact finite element method (FEM). By using ANSYS to analyze the model, the optimal results show that the peak contact pressure of optimal solution is 34.6% less than that of ideal model and that the distribution of contact pressure is reasonable.
出处 《四川大学学报(工程科学版)》 EI CAS CSCD 2003年第5期16-18,共3页 Journal of Sichuan University (Engineering Science Edition)
基金 油气藏地质开发工程国家重点实验室基金资助项目(PLN9923)
关键词 牙轮钻头 滑动轴承 有限元 接触 优化设计 roller bit sliding bearings FEA contact optimization design
  • 引文网络
  • 相关文献

参考文献5

  • 1伍开松.[D].西南石油学院,1986.
  • 2张茂.一种牙轮钻头滑动轴承[P].中国,实用新型,98228797.6.1999.10.16.
  • 3况雨春,马德坤,夏宇文.单牙轮钻头滑动轴承组接触应力分布研究[J].石油机械,2002,30(4):7-9. 被引量:3
  • 4张茂.一种牙轮钻头滑动轴承[P].中国,实用新型,98228797.6.1999.10.16.
  • 5伍开松.[D].西南石油学院,1986.

二级参考文献2

共引文献3

同被引文献67

引证文献11

二级引证文献48

;
使用帮助 返回顶部