期刊文献+

Constant Ripple Current Control for Switching DC-DC Converter

Constant Ripple Current Control for Switching DC-DC Converter
下载PDF
导出
摘要 The adapted DC-DC converters should be smaller in size and have a small output current ripple to meet the increasing demand for low voltages with high performance and high density micro processors for several microelectronic load applications. This paper proposes a DC-DC converter using variable on-time and variable switching frequency control enhanced constant ripple current control and reduced magnetic components. The proposed converter is realized by making the turn-offtime proportional to the on-time of the converter, according to the input and output voltage, thereby reducing the corresponding current ripple on output voltage in the continuous conduction mode. A Buck DC-DC converter using the proposed control strategy is analyzed in detail, along with some experimental results to show the performance and effectiveness of this converter.
出处 《Journal of Energy and Power Engineering》 2012年第9期1437-1441,共5页 能源与动力工程(美国大卫英文)
关键词 Constant ripple current DC-DC converter variable switching frequency continuous conduction mode indirect currentsensor magnetic component. DC-DC转换器 控制开关 纹波电流 连续导通模式 关断时间 输出电压 电流纹波 应用程序
  • 相关文献

参考文献14

  • 1Y. Panov, M.M. Jovanovic, Design and performance evaluation of low-voltage/high-current DC/DC on-board modules, IEEE Trans. on Power Elect. 16 (1) (2001) 26-33.
  • 2J.J. Lee, B.H. Kwon, Active-clamped ripple-free DC/DC converter using an input-output coupled inductor, IEEE Trans. on Ind. Elect. 55 (4) (2008) 1842-1854.
  • 3Y.T. Chang, C.A. Yeh, M. Hamaogi, F. Takahashi, Y.S. Lai, Current ripple reduction technique of DC-DC converter, in: The 7th International Conference on Power Electronics, Daegu, Korea, 2007, pp. 1087-1901.
  • 4M. Merisio, E.D. Bartolomeo, Advanced DC-DC controller design solutions to manage new application requirements in niPOLs (non-isolated-point-of-load converters), in: Proceedings of the IEEE International Symposium on Industrial Electronics, 2005, pp. 463-467.
  • 5K.Y. Lee, C.A. Yeh, Y.S. Lai, Design and implementation of fully digital controller for non-isolated-point-of-load converter with high current slew rate, in: 32nd Annual Conference on IEEE Industrial Electronics, Paris, France, 2006, pp. 2605-2610.
  • 6J. Fan, X. Li, J. Park, A. Huang, A monolithic buck converter using differentially enhanced duty ripple control, in: IEEE Custom Integrated Circuits Conference, San Jose, California, 2009, pp. 527-530.
  • 7P. Xu, M. Ye, F.C. Lee, Single magnetic push-pull forward converter featuring built-in input filter and coupled-inductor current doubler for 48 V VRM, in: 7th Annual IEEE Applied Power Electronics Conference and Exposition (APEC), Dallas, TX, USA, 2002, pp. 843-849.
  • 8G.B. Koo, G.W. Moon, M.J. Youn, New zero-voltage-switching phase-shift full-bridge converter with low conduction losses, IEEE Trans. on Ind. Elect. 52 (1) (2005) 228-235.
  • 9Y. Wen, S. Deng, H. Mao, I. Batarseh, Unified steady-state and dynamic modeling for symmetric and asymmetric half-bridge DC-DC converters with current doubler rectifiers, in: 20th Annual IEEE Applied Power Electronics Conference and Exposition (APEC), Austin, TX, 2005, pp. 1525-1530.
  • 10N.P. Papanikolaou, E.C. Tatakis, Active voltage clamp in flyback converters operating in CCM mode under wide load variation, IEEE Trans. on Ind. Elect. 51 (3) (2004) 632-640.

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部