期刊文献+

高能填料对星型GAP推进剂燃烧性能的影响 被引量:3

Influence of High Energy Fillers on Combustion Characteristics of Stellate GAP Based Propellant
下载PDF
导出
摘要 采用靶线法和单幅放大彩色摄影法分别测试了推进剂的燃速和火焰结构,研究了黑索今(RDX)、奥克托金(HMX)和高氯酸铵(AP)等高能填料的种类、粒度及其复配对星型聚叠氮缩水甘油醚(S-GAP)推进剂燃速、压强指数和火焰结构的影响。结果表明,以AP为填料的S-GAP推进剂的燃烧剧烈程度明显强于RDX和HMX基推进剂,AP基S-GAP推进剂的燃速明显高于RDX和HMX基GAP推进剂,尤其是细粒度AP可大幅度提高S-GAP推进剂的燃速;RDX或HMX与AP复配后,在一定程度上可降低S-GAP推进剂2~20MPa压强的压强指数。 Influences of the granularity of RDX, HMX and AP and their mixtures on the burning rate, pressure ex- ponent and flame structure of the Stellate GAP (S-GAP) based propellant were experimentally studied by the determination of burning rate and analysis of flame structure. Results show that the combustion of S-GAP based propellant with AP is obviously more intense than the propellants with RDX or HMX. Thus, the burning rates of S-GAP based propellant with AP, especially AP with small granularity, are obviously higher than those of the propellants with RDX or HMX. The pressure exponent of S-GAP based propellant at 2--20 MPa can be decreased by the mixtures of RDX or HMX with AP in a certain extent.
出处 《火炸药学报》 EI CAS CSCD 北大核心 2013年第2期52-56,共5页 Chinese Journal of Explosives & Propellants
基金 火炸药燃烧国防科技重点实验室基金资助(91040c3503011004)
关键词 物理化学 固体推进剂GAP推进剂 星型GAP 燃烧性能 填料 physical chemistry solid propellant GAP based propellant stellate GAP combustion characteristics filler
  • 相关文献

参考文献16

  • 1徐若千,姬月萍,丁峰,汪伟,兰英,刘亚静.三臂型叠氮含能增塑剂GAPA的合成与性能[J].含能材料,2009,17(6):681-684. 被引量:5
  • 2Wada Y, Tsutsumi A, Seike Y, et al. Combustion mechanism of tetraol glycidyl azide polymer[J]. Science and Technology of Energetic Materials, 2008,69 (5) : 143- 148.
  • 3Helmy A M. GAP Propellant {or Gas Generator Application. AIAA 87-1725 [R]. New York: AIAA, 1987.
  • 4Yoshi O. Thermal decompsiton of azide polymers[J]. Propellants, Explosives, Pyrotechnics, 1992, 17.. 226-231.
  • 5李倩,姚维尚,谭惠民.叠氮粘合剂与硝酸酯溶度参数的分子动力学模拟[J].含能材料,2007,15(4):370-373. 被引量:26
  • 6Qiu S J, Gan X X. Hydrogen bond effect of azide polyurethane elastomer by dynamic mechanical analysis [J]. Journal of Polymer Science, 2006, 44: 2841-2851.
  • 7Paletsky A A, Volkov E N, Korobeinichev O P, Tereshchenko A G, et al. Flame structure of composite pseudcr propellants based on nitramines and azide polymers at high pressure [J]. Proceedings of the Combustion Institute, 2007, 31: 2079-2087.
  • 8Paletskya A A, Korobeinicheva O P, Tereshchenkoa A G, et al. Flame structure of HMX/GAP propellant at high pressure [J]. Proceedings of the Combustion Institute, 2005, 30: 2105-2112.
  • 9Becksteada M W, Puduppakkama K, Thakre P, et al. Modeling of combustion and ignition of solid propellant ingredients [J]. Progress in Energy and Combustion Science, 2007, 33: 497-551.
  • 10Puduppakkam P V, Tanner M W, Beckstead M W. RDX/GAP pseudo-propellant combustion modeling. AIAA 2006-4926[R]. New York: AIAA, 2006.

二级参考文献75

共引文献129

同被引文献29

引证文献3

二级引证文献12

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部