摘要
本文设计了一种基于石墨烯片的频率可调太赫兹天线,采用了折叠缝隙结构并使用共面波导馈电方式,以更好地实现阻抗匹配.通过调控在缝隙之间添加的4个石墨烯片的电导率,改变缝隙天线的等效长度,使天线在两种不同工作模式下的谐振频率分别为230.5 GHz和270.5 GHz.除此之外,在天线下方加载了方形封闭谐振环(Closed-Ring Resonator,CRR)构成的超表面,并使其谐振频率与天线的谐振频率匹配,将z轴负方向的辐射进行反射,使天线在两种工作模式下的增益提高至5.41 dBi和7.63 dBi,与无反射结构时相比分别增长2.48 dBi和3.55 dBi.
In this paper,we propose a reconfigurable antenna using graphene which can work in terahertz band.The antenna use folded slot structure and coplanar waveguide to achieve impedance matching easily.By adjusting the conductivity of the four graphene sheets added between the slots,we can change the resonant frequencies of the antenna from 230.5 GHz to 270.5 GHz.In addition,a metasurface consisted of square closed-ring resonators(CRR)is under the antenna used to increase the gain of antenna.Because of the reflection of metasurface,the gain of antenna in two work mode increases 2.48 dBi and 3.55 dBi respectively.
作者
刘博文
徐航
张雅婷
李杰
姚建铨
LIU Bo-wen;XU Hang;ZHANG Ya-ting;LI Jie;YAO Jian-quan(Key Laboratory of Optoelectronic Information Technology Ministry of Education,Tianjin University,Tianjin 300072,China;Laoshan Laboratory,Qingdao,Shandong 266234,China)
出处
《电子学报》
EI
CAS
CSCD
北大核心
2024年第5期1421-1431,共11页
Acta Electronica Sinica
基金
崂山实验室科技创新项目(No.LSKJ202200801)
国家重点研发计划项目(No.2021YFB2800703)
国家自然科学基金(No.U22A2008)
电磁空间安全全国重点实验室开放基金。
关键词
太赫兹
石墨烯
折叠缝隙天线
可重构天线
超表面
共面波导
terahertz
graphene
folded slot antenna
reconfigurable antenna
metasurface
coplanar waveguide
