摘要
选择石墨烯/水性聚氨酯复配液作为功能整理剂,对3D打印柔性服装面料进行涂层处理,制备远红外3D打印柔性服装面料,并对其舒适性进行测试。采用扫描电子显微镜(SEM)对涂层前后3D打印柔性服装面料的表观形态进行表征。以升温效果为评价指标分析纳米石墨烯质量分数和涂覆量对升温效果的影响,进而确定最佳工艺为石墨烯质量分数2%,涂覆量200 mg/m2。结果表明:在此工艺条件下,3D打印柔性服装面料的远红外发射性能优良,且具有良好的耐久性和服用性能。
The graphene/waterborne polyurethane compound solution is selected as the functional finishing agent,and the 3 D printing flexible clothing fabric is coated to prepare far-infrared 3 D printing flexible clothing fabric,and its fabric comfort is tested.A scanning electron microscope(SEM)is used to characterize the apparent morphology of the 3 D printed flexible garment fabric before and after coating.Taking the heating effect as the evaluation index,the influence of the mass fraction of nano graphene and the coating amount on the heating effect is analyzed,and then the optimum process is determined:the mass fraction of graphene is 2%,and the coating amount is 200 mg/m2.The results show that under this process,the 3 D printed flexible garment fabric has excellent far-infrared emission performance,and has good durability and wearability.
作者
张紫阳
孟家光
杨豆豆
ZHANG Ziyang;MENG Jiaguang;YANG Doudou(College of Textile Science and Engineering,Xi’an Polytechnic University,Xi’an 710048,Shaanxi,China;Key Laboratory of Functional Textile Material and Product,Xi’an Polytechnic University,Ministry of Education,Xi’an 710048,Shaanxi,China)
出处
《上海纺织科技》
北大核心
2021年第5期26-29,38,共5页
Shanghai Textile Science & Technology
基金
国家支撑计划项目(2012BAF13B03)
陕西省科技统筹创新工程项目(2014SZS13-Z01)
关键词
织物
涂层处理
整理剂
舒适性
石墨烯
3D打印柔性服装
fabric
coating finish
finishing agent
comfortability
graphene
3D printing flexible clothing
