Transient Temperature Field Analysis of Brake in Nonaxisymmetric Three-dimensional Model

The disk-pad brake used in automobile is divided i nt o two parts: the disk, geometrically axisymmetric, and the pad, of which the geo metry is three-dimensional. In the course of braking, all parameters of the pro cesses (velocity, load, temperature, physicomechanical and tribological characte ristics of materials of the couple, and conditions of contacts) vary with the ti me. Considerable evidence has show that the contact temperature is an integral f actor reflecting the specific power friction influence at the combined effect of load, speed, friction coefficient, thermo physical and durability properties of materials of a frictional couple. Furthermore, the physic mechanical state of t he interface of the disk and pads is determined not only by the contact temperat ure but also by the nonstationary temperature field. Using the two-dimensional model for thermal analysis implies that the contact conditions and frictiona l heat flux transfer are independent of θ. This may lead to false thermal elast ic distortions and unrealistic contact conditions. An analytical model is presen ted in this paper for the determination of contact temperature distribution on t he working surface of a brake. To consider the effects of the moving heat source (the pad) with relative sliding speed variation, a transient finite element tec hnique is used to characterize the temperature fields of the solid rotor with ap propriate thermal boundary conditions. And the transient heat conduction problem can be solved as a nominal 3-D transient heat transfer problem with an immovab le heat source. Numerical results shows that the operating characteristics of th e brake exert an essentially influence on the surface temperature distribution a nd the maximal contact temperature. The temperature field presents a noaxisymmet ric characteristic (a function of θ) and proves to be strongly localized and po ssesses a sharp gradient in both axial and radial directions.

The disk-pad brake used in automobile is divided i nt o two parts: the disk, geometrically axisymmetric, and the pad, of which the geo metry is three-dimensional. In the course of braking, all parameters of the pro cesses (velocity, load, temperature, physicomechanical and tribological characte ristics of materials of the couple, and conditions of contacts) vary with the ti me. Considerable evidence has show that the contact temperature is an integral f actor reflecting the specific power friction influence...