期刊文献+

小径柞木真空干燥应力初步试验 被引量:1

Experimental Study on Vacuuming Drying Stress of Small Diameter Oak
下载PDF
导出
摘要 在真空干燥条件下试验建立了有关应力、含水率及时间之间的关系,分析了小径级柞木锯材在真空干燥过程中应力的发生和发展变化过程.试验表明:由于干燥前初始应力的差异,导致干燥过程中应力的性质有所不同.根据应力差异,应在干燥的不同阶段及时进行调湿处理,预防板材开裂. The relationship among the stress,moisture content and time span was set up.The small diameter oak lumber had been analyzed on the procedure which the stress produces,develops and changes in the vacuum condition.The experiment showed that the stress properties are different because starting states with the lumber stresses were not the same.The conditioning treatments should be done at the different drying stages according to the stress variations in order to prevent the lumber checking.
作者 王莉 尚延有
出处 《北华大学学报(自然科学版)》 CAS 2012年第4期454-456,共3页 Journal of Beihua University(Natural Science)
关键词 小径级 柞木 锯材 真空 干燥应力 small diameter oak lumber vacuum drying stress
  • 相关文献

参考文献3

二级参考文献18

  • 1[2]Keey R B,Langrish T A G,Walker J C F.Kiln-Drying of Lumber[M].New York:Verlag Berlin Heidelberg Springer,2000.
  • 2[3]McMillen J M.Drying stress in wood drying[J].Forest Products Journal,1955,5(1) :71.
  • 3[5]Gittus J H.Creep,viscoelasticity,and creep fracture in solids[A].John Wiley,Sons.Inc[C].New York:Verlag Berlin Heidelberg Springer,1975.
  • 4[6]Cai Zhiyong.Creep and creep-recovery models for wood under high stress levels[J].Wood and Fiber Science,2002,34 (3) :425-433.
  • 5[7]Oliver A R.A model of the behaviour of wood as it dries with special reference to eucalypt materials.Research report CM91-1.Civil and Mechanical Engineering Department[R].Australia:Univ Tasmania Hobart,1991.
  • 6[8]Haque M N,Langrish T A G,Keep.L-B,et al.Model fitting for visco-elastic creep of Pinus radiata during kiln drying[J].Wood Science and Technology,2000,34:447- 457.
  • 7[9]Wu QL.An investigation of some problems in drying of Tasmanian eucalypt timbers[D].Hobart:University of Tasmania,1989.
  • 8[10]Moren T J.Creep response to drying of timber boards of Scots pine[J].Forest Prod J ,1993(10) :58-64.
  • 9[11]Martensson A,Svensson S.Stress-strain relationship of dring wood:Part 1:development of a constitutive model[J].Holzforschung,1997,51(5):472-478.
  • 10[12]Martensson A,Svensson S.Stress-strain relationship of dring wood:Part 2 :Verification of a one-dimensional model and development of a two-dimensional model[J].Holzforschung,1997,51(6):565- 570.

共引文献21

同被引文献3

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部