期刊文献+

hBN含量对等离子喷涂NiCr/Cr_3C_2-hBN复合涂层力学性能的影响 被引量:7

Effect of h BN content on mechanical properties of plasma-sprayed NiCr/Cr_3C_2-h BN composite coating
原文传递
导出
摘要 采用化工冶金包覆、喷雾造粒和固相合金化技术以Cr3C2和hBN为核心制备了NiCr/Cr3C2-h BN复合粉体,并用等离子喷涂技术制备了NiCr/Cr3C2-hBN涂层,研究了涂层的显微结构、物相组成、显微硬度和结合强度。研究结果表明,等离子喷涂NiCr/Cr3C2-h BN复合涂层呈典型的层状结构,各层之间结合良好。涂层的显微硬度和结合强度均随hBN含量的增加逐渐降低,当hBN含量为20%时,涂层的显微硬度和结合强度分别为NiCr/Cr3C2涂层的66%和50%。涂层断裂位置发生在涂层内部,为典型的脆性断裂。 Taking hBN and Cr3C2 as core,NiCr/Cr3C2-hBN composite powder were prepared with the technologies of spray granulation,chemical and metallurgical coating and solid state alloying. The NiCr/Cr3C2-h BN composite coating was prepared by plasma-spray technology. Microstructure,phase composition,microhardness and tensile strength of the coating were investigated. The results show that the NiCr/Cr3C2-h BN composite coating consisted of typical lamellae and exhibited excellent binding strength. Both the microhardness and binding strength of the coating decrease with the increase of h BN content. When the hBN content is 20%,microhardness and tensile strength of the coating are 66% and 50% of these of the NiCr/Cr3C2 coating,respectively. The peeling occurs inside coating and is typical brittle fracture.
出处 《金属热处理》 CAS CSCD 北大核心 2015年第6期163-166,共4页 Heat Treatment of Metals
基金 国家自然科学基金(51471159) 河北省自然科学基金(E2015105068) 唐山市科技计划项目(14130286a) 唐山学院材料科学与工程重点学科(TSC2013003)
关键词 NiCr/Cr3C2-hBN复合涂层 等离子喷涂 显微硬度 结合强度 NiCr/Cr3C2-h BN composite coating plasma spraying microhardness tensile strength
  • 相关文献

参考文献13

  • 1金云学,岳佳锜,王昌华,钱智慧.球扁钢用铸铁轧辊表面等离子喷涂Cr_3C_2-25NiCr涂层工艺优化[J].金属热处理,2013,38(3):86-91. 被引量:13
  • 2金云学,岳佳锜,王昌华,钱智慧.铸铁轧辊表面Cr_3C_2-NiCr涂层的显微组织[J].金属热处理,2012,37(12):43-45. 被引量:5
  • 3蒋冰玉,刘世民,王日初,罗丰华.BN含量对BN/Ni(Cr)自润滑材料力学及摩损性能的影响[J].粉末冶金材料科学与工程,2009,14(1):57-62. 被引量:12
  • 4Lingzhong Du,Chuanbing Huang,Weigang Zhang,Tiegang Li,Wei Liu.Preparation and wear performance of NiCr/Cr 3 C 2 –NiCr/hBN plasma sprayed composite coating[J]. Surface & Coatings Technology . 2011 (12)
  • 5Yuxia Cao,Lingzhong Du,Chuanbing Huang,Wei Liu,Weigang Zhang.Wear behavior of sintered hexagonal boron nitride under atmosphere and water vapor ambiences[J]. Applied Surface Science . 2011 (23)
  • 6M. Nose,T. Kawabata,T. Watanuki,S. Ueda,K. Fujii,K. Matsuda,S. Ikeno.Mechanical properties and oxidation resistance of CrAlN/BN nanocomposite coatings prepared by reactive dc and rf cosputtering[J]. Surface & Coatings Technology . 2011
  • 7Lingzhong Du,Weigang Zhang,Wei Liu,Jingmin Zhang.Preparation and characterization of plasma sprayed Ni 3 Al–hBN composite coating[J]. Surface & Coatings Technology . 2010 (7)
  • 8Lingzhong Du,Chuanbing Huang,Weigang Zhang,Jingmin Zhang,Wei Liu.Effect of NiCr Clad BaF2·CaF2 Addition on Wear Performance of Plasma Sprayed Chromium Carbide-Nichrome Coating[J]. Journal of Thermal Spray Technology . 2010 (3)
  • 9Chuanbing Huang,Lingzhong Du,Weigang Zhang.Effects of solid lubricant content on the microstructure and properties of NiCr/Cr 3 C 2 –BaF 2 ·CaF 2 composite coatings[J]. Journal of Alloys and Compounds . 2009 (1)
  • 10T.S. Sidhu,S. Prakash,R.D. Agrawal.Hot corrosion studies of HVOF sprayed Cr 3 C 2 –NiCr and Ni–20Cr coatings on nickel-based superalloy at 900 °C[J]. Surface & Coatings Technology . 2006 (3)

二级参考文献32

共引文献27

同被引文献50

  • 1孟祥军,刘秀波,刘海青,郑晨,孙承峰,王明娣,齐龙浩.热处理对NiCr/Cr_3C_2-WS_2复合涂层组织与性能的影响[J].材料热处理学报,2013,34(S2):188-193. 被引量:7
  • 2Du Lingzhong, Huang Chuanbing, Zhang Weigang, et al. Effect of NiCr clad BaF2 · CaF2 addition on wear performance of plasma sprayed chromium carbide-Ni chrome coating [ J ]. Journal of Thermal Spray Technology, 2010, 19(3): 551-557.
  • 3Cao Yuxia, Huang Chuanbing, Liu Wei, et al. Effects of boron carbide content on the micrnstructure and properties of atmospheric plasma- sprayed NiCoCrA1Y/A1203-B4C composite coatings [ J]. Journal of Thermal Spray Technology, 2014, 23 (4) : 716-724.
  • 4Huang Chuanbing, Du Lingzhong, Zhang Weigang. Preparation and characterization of atmospheric plasma-sprayed NiCr/Cr3C2-BaF2 · CaF2 composite coating [ J ]. Surface and Coating Technology, 2009, 203(20/21 ) : 3058-3065.
  • 5Du L Z, Zhang W G, Liu W, et al. Preparation and characterization of plasma sprayed Ni3AI-hBN composite coating[ J]. Surface and Coating Technology, 2010, 205(7): 2419-2424.
  • 6Bounazef M, Guessasma S, Saadi B A. The wear deterioration and transformation phenomena of abradable coating BN-SiA1-Bounding organic element caused by the friction between the blades and the turbine casing[J]. Material Letter, 2004, 58(27/28) : 3375-3380.
  • 7Eichle J, Lesniak C. Boron nitride(hBN) and hBN composites for high- temperature applications [ J ]. Journal of European Ceramic Society, 2008, 28: 1105-1109.
  • 8Du L Z, Huang C B, Zhang W G, et al. Preparation and wear performance of NiCr/Cr3C2-NiCr/hBN plasma sprayed composite coating J ]. Surface and Coating Technology, 2011, 205 ( 12 ) : 3722-3728.
  • 9Mercier D,Gauntt B D, Brochu M. Thermal stability and oxidation behavior of nanostructured NiCoCrA1Y coatings [ J ]. Surface and Coatings Technology, 2011,205 ( 17/18 ) :4162 - 4168.
  • 10Li Z M, Qian S Q ,Wang W. Characterization and oxidation behavior of NiCoCrAIY coating fabricated by eleetrophoretie deposition and vacuum heat treatment[ J]. Applied Surface Science,2011,257(10) :4616 -4620.

引证文献7

二级引证文献19

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部