摘要
以极限平衡理论为基础,结合应力平衡原理,提出一种计算矩形巷道塑性区宽度的新方法。以张家峁煤矿的巷道为算例,应用新方法和等效圆方法分别计算巷道塑性区宽度,并将两种方法的计算结果与数值模拟结果进行对比分析。结果表明,计算塑性区宽度与数值模拟的结果较接近,比等效圆方法更精确,能够为煤矿巷道支护设计提供更准确的参数。
Based on the limit equilibrium theory,and combined with the stress balance principle,a new method for calculating the width of plastic zone in rectangular coal drift was proposed.Taking the drift of Zhangjiamao coal mine for an example,the width of plastic zone was calculated by new method and equivalent circle method.Then,the calculation results and the numerical simulation results of two methods were compared.The results showed that the width of the plastic zone calculated by the new method was close to the numerical simulation results,being more precise than the equivalent circle method,which can provide more accurate parameters for the support design in coal drift.
出处
《矿业研究与开发》
CAS
北大核心
2015年第1期60-63,共4页
Mining Research and Development
基金
陕西省教育厅科研计划资助项目(2013JK0961)
关键词
塑性区宽度
矩形煤巷
极限平衡
高跨比
数值模拟
Width of plastic zone,Rectangular coal drift,Limiting equilibrium,High-span ratio,Numerical simulation