摘要
Laser and hot air reflow soldering of PBGA solder ball was investigated. Experimental results showed that surface quality and shear strength of solder bump reflowed by laser was superior than the solder bump by hot air, and the microstructure within the solder bump reflowed by laser was much finer. Analysis on interfacial reaction showed that eutectic solder reacted with Au/Ni/Cu pad shortly after the solder was melted. Interface of solder bump reflowed by laser consists of a continuous AuSn 4 layer and remnant Au element. Needle like AuSn 4 grew sidewise from interface, and then spread out to the entire interface region. A thin layer of Ni 3Sn 4 intermetallic compound was found at the interface of solder bump reflowed by hot air, and AuSn 4 particles distributed within the whole solder bump randomly. The combination effect of the continuous AuSn 4 layer and finer eutectic microstructure contributes to the higher shear strength of solder bump reflowed by laser.
Laser and hot air reflow soldering of PBGA solder ball was investigated. Experimental results showed that surface quality and shear strength of solder bump reflowed by laser was superior than the solder bump by hot air, and the microstructure within the solder bump reflowed by laser was much finer. Analysis on interfacial reaction showed that eutectic solder reacted with Au/Ni/Cu pad shortly after the solder was melted. Interface of solder bump reflowed by laser consists of a continuous AuSn 4 layer and remnant Au element. Needle like AuSn 4 grew sidewise from interface, and then spread out to the entire interface region. A thin layer of Ni 3Sn 4 intermetallic compound was found at the interface of solder bump reflowed by hot air, and AuSn 4 particles distributed within the whole solder bump randomly. The combination effect of the continuous AuSn 4 layer and finer eutectic microstructure contributes to the higher shear strength of solder bump reflowed by laser.
