摘要
介绍了嵌入式软件模块的调试方法和调试环境。由于底层嵌入式软件的特殊性 ,一般在原型板调试时才开始进行底层嵌入式软件的调试工作。为了加快项目的开发进度 ,建议在硬件原型板制板之前开始嵌入式软件模块调试 。
Because of the special character of low-level embedded software, it is usually debugged after the hardware prototype board is available. In order to speed up the development process, this paper suggests debugging low level embedded software before the prototype manufacturing. It may eliminate coding error as soon as possible in the development.
出处
《电子工程师》
2004年第8期53-56,共4页
Electronic Engineer
关键词
底层嵌入式软件
模块调试
C程序
low level embedded software, module debugging, C code
