摘要
根据GB50010—2002《混凝土结构设计规范》规定的单向受弯构件正截面承载力计算方法确定梁的单向受弯正截面承载力.利用该规范附录F的原理编制计算程序,计算截面高宽比1~4、斜弯角0°~90°范围内,配筋率分别约为最大配筋率、最小配筋率和经济配筋率时双向受弯构件的正截面承载力,从而得出了各种条件下正截面承载力较单向受弯降低不大于5%时外荷载的最大允许斜弯角βmax.最后得出βmax随着截面高宽比和配筋率增大而减小等几条结论。
According to GB50010-2002 Code for design of concrete structures, the normal section bearing capacity of reinforced concrete beam subjected to single bending is determined. The calculation program is established from the appendix F of GB50010-2002 Code for design of concrete structures. The normal section bearing capacity of reinforced concrete beam, which subjected to inclined bending under the cross section depth-width ratio at the range of 1 to 4, the load inclination at 0 to 90 degree, the tension reinforcement ratio at minrto maxr, is obtained by the program. Therefore the maximum limit load inclinations maxbare derived of which the bearing capacity declined does not exceed 5% under various conditions. Finally several conclusions, such as the maxb are decreased with the increase of the ratio of depth to width and the ratio of tension reinforcement of the cross section, are reached.
出处
《五邑大学学报(自然科学版)》
CAS
2004年第3期7-12,共6页
Journal of Wuyi University(Natural Science Edition)
关键词
钢筋混凝土
双向受弯
正截面承载力
斜弯角
配筋率
reinforced concrete
inclined bending
normal section bearing capacity
load inclination
tension reinforcement ratio