不同侧方加压器对弯曲根管充填质量的影响
Finger spreaders and quality of filling density in curved canals
出处
《局解手术学杂志》
2004年第5期349-350,共2页
Journal of Regional Anatomy and Operative Surgery
参考文献13
-
1Berry KA, Primack PD, Loushine RJ, et al. Nickel-titanium versus stainless-steel finger spreaders in curved canals[J]. Endod, 1998, 24(11): 752-754.
-
2Schmidt KJ, Walker TL, Johnson JD, et al. Comparison of nickel-titanium and stainless-steel spreader penetration and accessory cone fit in curved canals[J]. Endod, 2000, 26(1): 42-44.
-
3Ingle JI, Bakland LK. Endodontics[M].5th Edition. Hamilton: BC Decker, 2002.
-
4Hatton JF , Wagner G, Stewart GP, et al. The effect of condensation pressure on the apical seal[J]. Endod, 1988, 14(6): 305-308.
-
5Holcomb JQ, Pitts DL, Nicholls JI. Further investigation of spreader loads required to cause vertical root fracture during lateral condensation[J]. Endod, 1987, 13(6): 277-284.
-
6Kuhn G, Jordan L. Fatigue and mechanical properties of nickel-titanium endodontic instruments [J]. Endod, 2002, 28(10): 716-720.
-
7Joyce AP, Loushine RJ, West LA, et al. Photoelastic comparison of stress induced by using stainless-steel versus nickel-titanium spreaders in vitro[J]. Endod, 1998, 24(11): 714-715.
-
8Shull CC, Loushine RJ, West LA, et al. A comparison of nickel titanium versus stainless steel spreaders in curved canals[J]. Endod, 1997, 23(4): 255-256.
-
9Sobhi MB, Khan I. Penetration depth of nickel titanium and stainless steel finger spreaders in curved root canals[J]. Coll Physicians Surg Pak, 2003, 13(2): 70-72.
-
10Davis RD, Marshall JG, Baumgartner JC. Effect of early coronal flaring on working length change in curved canals using rotary nickel-titanium versus stainless steel instruments[J]. Endod, 2002, 28(6): 438-442.
-
1夏智敏,彭彬,边专,樊明文.2种侧压器进入弯曲根管的深度及充填质量的比较[J].华西口腔医学杂志,2006,24(5):429-431. 被引量：3
-
2夏智敏,彭彬,边专,樊明文.两种侧方加压器进入弯曲根管深度的实验研究[J].牙体牙髓牙周病学杂志,2004,14(10):567-570. 被引量：4
-
3夏智敏,彭彬,边专,樊明文.比较两种锥度牙胶尖侧方加压的充填质量[J].现代口腔医学杂志,2007,21(1):66-68. 被引量：2
-
4胡晓春,尹笑艳,隋晓光.3种根管充填技术体外模型充填密度的对比[J].中国卫生工程学,2006,5(5):263-265.
-
5杨国彪,夏凌云,陈菁,陈晓春,尹仕海,陈新梅.三种根管充填侧方加压器空间可利用度的比较[J].牙体牙髓牙周病学杂志,2008,18(2):98-100.
-
6陈凯,尚光伟,杨启祥,杨华伟,严雪喻,钱浩,黄冬梅.高温热塑充填技术与冷牙胶侧方加压充填技术根尖封闭性体外实验研究[J].实用临床医药杂志,2014,18(13):69-72. 被引量：9
-
7陈永辉,赖毅伟.连续波充填技术的临床评价[J].福建医科大学学报,2009,43(5):422-424.
-
8程靖,叶茂昌.连续波热牙胶根管充填技术根尖封闭性的体外实验研究[J].中国临床保健杂志,2010,13(4):369-371. 被引量：6
-
9张楠,申海,刘金明.热牙胶垂直加压充填技术对根尖封闭性能的研究[J].齐齐哈尔医学院学报,2015,36(31):4689-4690. 被引量：4
-
10梁建平,林志立,张嵘.Hero642联合ProTaper应用于磨牙根管预备的临床分析[J].广东牙病防治,2008,16(10):458-459. 被引量：2
