期刊文献+

一种多普勒频偏估计方法及分析 被引量:1

Design and Analysis of a Scheme for the Doppler Shift Estimation
下载PDF
导出
摘要 利用有效到达径上信道估计值包络的电平通过率,估计出时变多径信道的多普勒频偏,并分析了影响该频偏估计的几个系统参数,得到了合适的系统参数选取原则.同时在理论上分析了噪声环境下电平通过率的估计偏移,提出了修正方法,使得通信系统在各种移动速度和信噪比下都具有较高的估计精度. The Doppler-shift of the time-varying multi-path channel can be estimated by calculating the level crossing rate (LCR) of the signal envelope of the channel coefficient estimates on the effective fingers. Also some parameters relating to the Doppler shift are analyzed, and an improved estimation method to get the high estimation accuracy in all kinds of velocity and signal-to-noise ratio is raised.
出处 《应用科学学报》 CAS CSCD 2004年第4期443-448,共6页 Journal of Applied Sciences
基金 国家863计划资助项目(2001AA123015)
  • 相关文献

参考文献8

  • 1Jakes W C. Microwave Mobile Communications [M].NJ :IEEE Press, 1974.12- 13.
  • 2Cavers J K. An analysis of pilot symbol assisted modulation for Rayleigh fading channel [J]. IEEE Trans on VT, 1991,40(4) :683- 693.
  • 3Sampath A, Holtzman J. Estimation of maximum Doppler frequency for handoff decisions [C]. Proc IEEE VTC, 1993. 859-862.
  • 4MAZhangyong YANYongqing ZHAOChunming YOUXiaohu.An Improved Channel Estimation Algorithm Based on Estimating Level Crossing Rate for the CDMA Receiver[J].Chinese Journal of Electronics,2003,12(2):235-238. 被引量:12
  • 5Kawabata K, Nakamura T, Fukuda E. Estimating velocity using diversity reception [C]. Proc IEEE VTC, 1994. 371-374.
  • 6Tepedelenlioglu C, Giannakis G B. Estimation of Doppler spread and signal strength in mobile communications with application to handoff and adaptive transmission [J]. Wirel Commun Mob Comput of Wiley, 2001,1 (2): 221 - 242.
  • 7Ehrman L. On the accuracy of the envelope method for the measurement of Doppler spread [J]. IEEE Trans on Comm, 1969,17(5): 578- 581.
  • 8Negi R, Cioffi J. Pilor tone selection for channel estimation in a mobile OFDM systems [J]. IEEE Trans Consum Electron,1998,44(8) :1122-1128.

共引文献11

同被引文献7

引证文献1

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部