摘要
根据南钢烧结厂 3 9m2 烧结机的头、尾轮齿板 ,轨道和滑道中心线偏差的检测结果 ,分析了烧结机跑偏的原因 。
Based on the examination of center lines of sintering machine drive plate, running track and sliding track, the reason of sintering machine deviation was found out And then some adjusting measures and their effect were presented in this paper
出处
《烧结球团》
北大核心
2005年第1期31-34,共4页
Sintering and Pelletizing
