8Behrens A,Ginzel J.An open numerical control architecture for electo-discharge machining.Proc.13th International Symposium for Electro Ma chining (ISEMXⅢ),Bilbao,2001:161 ～ 170.
9Behrens A,Ginzel J.A comparison of different input values for gap-width controllers used in electro-discharge machining.Proc.13th Inter national Symposium for Electro Machining (ISEMXIII),Bilbao,2001:93 ～ 107.
10Behrens A, Ginzel J. An open numerical control architecture for electo - discharge machinlng[J] . Proc. 13th International Symposium for Electro Ma chining (ISEMX Ⅲ), Bilbao, 2001:161 - 170.
