摘要
Non-consistency of stress results is of ten observed during field measurements. In some cases, even the rneasurernents are made at the same location in a massive rockrnass, the results can vary widely. In order to solve the problem, extensive research has been carried out to study the major factors wh1ch rnay affect stress deterrnlnation. They include the rock behaviour and the stress state. For rocks showing non-isotropic behaviour, the values of Young’s modulus and Poisson ratio vary with the orientation of loading and measurement. Stress condition in the rock affects the rock behaviour. Furtherrnore, the loading condition on rock samples durlng laboratory tests is different from in the field and therefore the determined e1astic constants may not represent the field condi tion. In general , the Young’s modulus may depend on the orientation, the loading path, the stress magnitude and the stress ratio. This paper examines in detail the effects of those factors, especially for rocks showing transversely isotropic behaviour. It is found that the discrepancy of stress results from field measurernents in this type of rock is mainly due to over simplification of the rock behavior and inadequate use of elastic constants of the rock during stress calculation. A case study is given,which indicates the significance of these factors and demonstrates the proper procedure for stress calculation from measurements.
Non-consistency of stress results is of ten observed during field measurements. In some cases, even the rneasurernents are made at the same location in a massive rockrnass, the results can vary widely. In order to solve the problem, extensive research has been carried out to study the major factors wh1ch rnay affect stress deterrnlnation. They include the rock behaviour and the stress state. For rocks showing non-isotropic behaviour, the values of Young's modulus and Poisson ratio vary with the orientation of loading and measurement. Stress condition in the rock affects the rock behaviour. Furtherrnore, the loading condition on rock samples durlng laboratory tests is different from in the field and therefore the determined e1astic constants may not represent the field condi tion. In general , the Young's modulus may depend on the orientation, the loading path, the stress magnitude and the stress ratio. This paper examines in detail the effects of those factors, especially for rocks showing transversely isotropic behaviour. It is found that the discrepancy of stress results from field measurernents in this type of rock is mainly due to over simplification of the rock behavior and inadequate use of elastic constants of the rock during stress calculation. A case study is given,which indicates the significance of these factors and demonstrates the proper procedure for stress calculation from measurements.
关键词
岩石
应力分析
系数变化
静水力学性质
超声波波速
试验研究
in-situ stress, overcoring, transverse isotropy, microfractures, Young 's modulus,stress state
