摘要
分别采用正交车铣和车削对弱刚度细长杆类零件进行了精加工试验研究,试验结果表明。
The experiment on finish machining the slender rod with weak rigidity by the orthogonal turn milling and the turning were done respectively. It is shown that the smaller surface roughness and the better machining precision can be gained by orthogonal turn milling machining than the traditional turning machining.
出处
《新技术新工艺》
2005年第4期26-27,共2页
New Technology & New Process
基金
国家"8 6 3"计划基金项目 ( 2 0 0 3AA4 2 4 0 2 0 )
辽宁省博士启动基金项目 ( 2 0 0 110 2 0 34)
