摘要
由于拉伸件在拉伸后边缘不平整,一般需要修边才能达到要求,通常采用侧切和旋切模实现。本文针对旋切模的设计方法做一简单介绍。
Because after being drawn the edge of a drawing piece is no flattening generally it needs edge trimming to meet the demand usually realized by side-cutting and turn-cutting dies. This paper gives a brief introduction of design methods of a turn-cutting die.
出处
《模具制造》
2005年第5期22-24,共3页
Die & Mould Manufacture
关键词
旋切模
拉伸件
滑块
干涉
a turn-cutting die
drawing piece
slide block
interference
