期刊文献+

一种微通道换热器的设计与分析(英文) 被引量:3

Design and Analysis on a Microchannel Heat Exchanger
下载PDF
导出
摘要 设计了一种用来测试微通道换热性能的实验装置。该系统由微通道换热器、模拟热源、微型水泵、连通管、测试三通及其它测试元件构成。通过检测温度、压力和流量等参数能够得到微通道的传热和摩阻参数。针对该实验装置,对微通道中流体的压降和传热分别进行分析和研究。实验表明,当微通道水力直径为381μm时,宏观理论公式已不适用于微通道摩阻及其换热的计算。此时,微通道的摩阻比宏观理论计算值小31.6%~41.9%;微通道结构具有良好的换热性能,其Nu可达9.2。 An experimental apparatus is developed for testing the heat-exchange performance of microchannel structures. It consists of microchannel heat exchangers,a simulated heat source,a micro-pump,a few of pipes,some three-way pipes and other test devices. The heat exchange coefficients and the fluid resistant in microchannels can be obtained by testing temperature,pressure and flow rate. The fluid resistance and heat transfer performance of microchannels are analyzed and investigated based on this experimental apparatus. It is shown that classical macroscopic formulas are not applicable for calculating friction resistance and heat exchange coefficients when channel hydraulic diameter is 381 μm. In this case,the flow resistance number is from 31.6% to 41.9% smaller than that of calculated valne,and the structure has a satisfied heat transfer performance with Nussle number being 9.2.
出处 《微纳电子技术》 CAS 2005年第5期227-232,共6页 Micronanoelectronic Technology
基金 Supported by the National Nature Science Fundation of China (10476019) Youth Scientific Research W orkstation inXidian University
关键词 微通道 换热器 设计 实验装置 换热性能 微型水泵 测试元件 通过检测 理论公式 通道结构 连通管 摩阻 等参数 计算值 传热 宏观 microchannel heat exchanger flow resistance hydraulic diameter Nussle number
  • 相关文献

参考文献9

  • 1JIANG L N, WONG M, ZOHAR Y. Amicro-channel heat sink with integrated temperature sensor for phase transition study [A]. Proceedings of the IEEE Micro Electro Mechanical Systems (MEMS) [C] . 1999. 159-164.
  • 2MISSAGGIA L J, WALPOLE J N. A microchannel heat sink with alternating directions ofwater flow in adjacent channels [J] . SPIE Intergrated Optoelectronics for Communicationand Processing, 1991, 106-111.
  • 3TAY ANDREW A O, TAY FRANCIS E H, LI W J. Analytical study on a MEMS micro-coolingsystem for cooling of flip chips [A] . SPIE Part of the Conference on Design,Characterization, and Packging for MEMS and Microelectronics [C] .Australia: Royal PinesRest, Queensland, 1999. 3893: 82-93.
  • 4TUCKERMANN D B, PEASER R F. Optimized convective cooling using micromachinedstructure [J] . Journal of ElectroChamical Society, 1982, 129 (3): 98C.
  • 5YANG S M, TAO W Q. Heat Transfer (Ed.3) [M] . Beijing:Higher Education Press, 1998.
  • 6ELISABETH V, NICO F D R. Microfluidic meets MEMS [J] . Proceedings of the IEEE,2003, 91 (6): 930-953.
  • 7GAO D R, WU X M. Engineering Hydro-Mechanics (Ed.2)[M] . Beijing: EngineeringIndustry Press, 1999.
  • 8WANG H X, KANG C X, LIU H L. An approach for measuring performance parameters ofmicrochannles [A] . Proceedings of EME2003 [C] . China Electronic Association, 2003.11-15.
  • 9JIA J Y, WANG W D, WANG H X. Research on a microchannel heat exchanging systembased on thermoelectric control [A] . Proceedings of the Twentieth Annual IEEESemiconductor Thermal Measurement and Management Symposium [C] .USA: San Jose, 2004.225-230.

同被引文献19

引证文献3

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部