摘要
采用适合高Ｃｒ含量合金的晶间腐蚀试验方法（沸腾６５％ＨＮＯ。＋０．１％ＨＦ溶夜浸渍试验）和在３１６℃、５０％ＮａＯＨ溶液中的慢应变速率试验（ＳＳＲＴ）．研究了热处理对６９０合金晶间腐蚀和碱应力腐蚀性能的影响．热处理包括不同固溶温度（９５０－１１５０℃）及特殊热处理（Ｔ．Ｔ７１５℃）时不同保持时间（２～３０ｈ），根据试验结果．推荐６９Ｏ合金的热处理条件是；固溶温度应＜１１００℃，在７１５℃特殊热处理保持时间１５ｈ。
Alloy 690 is a new high chromium nickel base alloy that is promising as an advanced steam generator tubing materials. Authors have studied on the effect of heat treamtment on the corrosion resistance of alloy 690. Test materials were treated at 715℃ for 2～30 hours after final annealing at low temperature such as 950℃ to high temperature such as 1150℃.From the view point of the intergranular corrosion in the boiling solution of 65% HNO3+ 0. 1 % HF and the stress corrosion cracking(SCC) resistance in 50 NaOH solution, the following heat treatment condition is considered to be optium for alloy 690. The mill annealing temperature is less 1100℃, thermal treatment 715℃ for 15 hours.
出处
《核动力工程》
EI
CAS
CSCD
北大核心
1995年第4期336-341,共6页
Nuclear Power Engineering
关键词
合金
晶间腐蚀
应力腐蚀
热处理
固溶
Alloy 690 Intergranular corrosion Stress corrosion Mill annealaing Holding time at thermal treatment
