摘要
图1所示模具为组合型多次拉深模。该模具的结构有如下特点。 1.工作零件可方便更换此模具除了上模固定座8和模架之外,其余零件都是活动的,可根据需要进行更换。拉深凸模6用螺栓7固定在上模座8上,凹模9用螺钉16固定在下模座上,并用圆锥销15定位,凹模套13用螺钉14顶紧。凸模柄与模座孔的配合,凹模9与下模座之间的配合,凹模套13的外径与凹模9的配合都统一采用 H7/f6。更换凸模6、凹模套13、顶杆5时可以不卸下模架。
出处
《模具技术》
1995年第5期52-54,共3页
Die and Mould Technology