期刊文献+

用负反馈控制锁模技术产生ps激光脉冲

GENERATION OF PICOSECOND PULSE BY NEGATIVE FEEDBACK-CONTROLLED MODE-LOCKED Nd: GLASS LASER
下载PDF
导出
摘要 在一台磷酸盐Nd:glass振荡器上,利用负反馈控制锁模技术,获得了稳定的、接近变换极限的ps激光单脉冲输出,为固体激光高亮度源提供了良好的种子光。 AbstractNegative feedback controlled mode locking techinque was applied on a phosphate Nd:glass oscillator. The pulse intensity in the cavity was kept at a low level to avoidself-phase modulation and other nonlinear effects.The building time of mode lockedpulse was prolonged to approximately 10 micro-seconds. As a result, a neartransform-limited picosecond laser pulse was obtained.It provided a good light seed forchirped pulse aplification system.Figure 2 is the scheme of the negative feedback controlled circuit.This circuit put ahigh voltage pulse, which is nearly propotional to the light pulse intensity in the cavity, onthe crystal of Pockels cell to change the loss of the cavity.A single pulse was dumped from the cavity by pulse selector which consisted apolarizer, a Pockels cell and the relative circuit.The pulse duration and the bandwidth of the output picosecond pulse were measured.The result are shown in Figure 6 and Figure 7.
出处 《强激光与粒子束》 EI CAS CSCD 1995年第2期304-308,共5页 High Power Laser and Particle Beams
基金 中国工程物理研究院科学基金
关键词 负反馈控制 锁模 ps脉冲 激光 Feedback control Laser mode locking Laser pulses
  • 相关文献

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部