摘要
通过对HC、CVC和PC三种新一代薄带冷轧机型对比性软件试验结果，分析它们在板形调控性能和辊间接触压力峰值上的优劣，提出板形控制的最佳执行路线，提高5机架连轧机板形控制的具体方法，论述了薄带冷轧机的发展趋势。
A comparative simulation of the behavior of three typical new thin strip cold rolling mills, HC-, CVC- and PC-typed mills,was accomplished for a comparision of their performance in sheet shape control. Theleffectiveness of these mills in controlling the roll gap and the contact pressure between the rolls are evaluated. Discussions on automatic sheet shape control system and key effective factors of tandem cold mills8 are covered along with an overview of the technological development tendency.
出处
《上海金属》
CAS
1995年第4期1-8,共8页
Shanghai Metals
关键词
冷轧机
薄带
板形控制
钢带
Cold Rolling Mill, Thin Strip, Sheet Shape Control
