摘要
介绍了影响激光驱动超高速发射技术的各种因素。分析了激光能量、激光光束空间分布对飞片发射速度及完整性的影响和飞片靶镀膜工艺对飞片速度及完整性的影响。结果表明:空间分布为"平顶型"的激光束有利于发射出完整的飞片。在膜与基底之间增加过渡层Cr可以大大提高膜与基底之间的附着力,从而提高飞片的发射速度。实验上利用波长1 064 nm、脉宽10 ns、能量835 mJ的激光使厚度5μm、直径1 mm的铝飞片的发射速度达到10.4 km/s。大大提升了对微米级空间碎片速度的发射能力。
The paper introduces the factors that influence the technologies for laser-driven flyer hypervelocity launch, and studies the effects of laser energy, spatial distribution of laser beam and deposition techniques of coatings on the velocity and integrity of flyers. The results indicate that the spatially 'flat cap' laser beam can launch flyers of good integrity. Adding a Cr film between Al coating and substrate can enhance the adhesion between them, and also enhance the flyer velocity distinctly. With a laser of 1064 nm wavelength and 10 ns pulse duration at laser energy of 835 mJ, the flyer driven out can reach a velocity of 10.4 km/s, whose thickness is 5 μm and diameter is 1 mm.
出处
《强激光与粒子束》
EI
CAS
CSCD
北大核心
2010年第12期3011-3014,共4页
High Power Laser and Particle Beams
基金
国家国防科技工业局空间碎片专题研究项目(kjsp06209)
