期刊文献+

周向进口畸变对压气机失速过程的影响 被引量:11

ANULAR INLET DISTORTIONS INFLUENCE ON A LOW-SPEED AXIAL COMPRESSOR
下载PDF
导出
摘要 本文对一台带有不同周向进口畸变装置的三级、低速、轴流压气机进行实验研究。研究结果发现周向进口畸变对压气机失速过程的影响包括了最初始的大时间尺度扰动产生的位置与条件;大时间尺度扰动失速先兆向脉冲型失速先兆的转化,以及大时间尺度扰动失速先兆尺度随转子转动方向的逐渐减小。说明局部扰动和系统特性之间存在一定的相互关系。 Experimental research was carried on a three-stage low-speed axial compressor with different inlet distortion. It was discovered that while in many cases the stall precursors were the short length scale spikes, there were some cases where the compressor instability was triggered after the disturbances going through a long-to-short length scale transition. Along axis running direction, the scale of long length scale disturbances decreased.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2005年第6期931-934,共4页 Journal of Engineering Thermophysics
基金 自然科学基金资助项目(No.50176050)
关键词 压气机 失速 扰动 进口畸变 轴流压气机 失速先兆 畸变 进口 周向 局部扰动 compressor rotating stall disturbance inlet distortion
  • 相关文献

参考文献6

  • 1J P Longley. Measured and Predicted Effects of Inlet Distortion on Axial Compressors. ASME 90-GT-214, 1990.
  • 2T Peters, T Burgener and L Fottner. Effects of Rotating Inlet Distortion on A 5-Stage HP-Compressor. ASME 2001-GT-0300, 2001.
  • 3K Viswanath and M Govardhan. Effect of Circumferential Inlet Flow Distortion and Swirl on The Flow Field of An Axial Flow FanStag. ASME 96-GT-263, 1996.
  • 4Hynes, T P and Greitzer, E M. A Method for Assessing Effects of Inlet Flow Distortion on Compressor Stability.In: Stability, Stall and Surge in Compressors and Pumps.ASME Winter Meeting, New Orleans, 1984, also Journal of Engineering for Power, 1986.
  • 5Epstein A H, Ffowcs Williams J E and Greitzer E M.Active Suppression of Aerodynamic Instabilities in Turbomachinery. AIAA J. Propulsion and Power, 1989, 5(2):204-211.
  • 6Chaoqun Nie, Gang Xu, Xiaobin Cheng, et, al. Micro Air Injection and Its Unsteady Response in a Low-Speed Axial Compressor. ASME J. Turbomachinery, 2002, 124(4):572-579.

同被引文献144

引证文献11

二级引证文献70

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部