摘要
利用复合生物吸附剂FY01与活性污泥作为吸附材料，探讨了柱式生物曝气法对高浓度含铬电镀废水的生物吸附效果。研究结果表明，FY01性能稳定，耐进水pH冲击能力较强。当进水pH=2—5、流速为500mL／h时，10gFY01和5g活性污泥联合处理60．4mg／L含铬电镀废水2h后，铬的去除率达78％以上；在4℃冰箱和23—28℃实验室保存50d的FY01对铬的去除分别在78％～83％和77％-84％之间。柱式生物曝气吸附法对含铬废水的处理效果理想，运行稳定。串联处理2000mL总Cr、Cu^2＋和COD浓度分别为60．4、4．51和48．2mg／L的电镀废水2h后，去除率分别高达92．1％、99．2％和71．4％。
Complex biosorbents FY01 and activated sludge were utilize on biosorption of chromium-electroplated wastewater by bio-aerobic column. The results showed that the stability of the FY01 was marked, and the feasible pH of wastewater was wide. When influx was 500 mL/h,pH was 2 - 5, the removal rate of 60.4 mg/L chromium by 10 gram FY01 and 5 gram activated sludge together for 2 hours was exceeded 78% , and the value could also reach 78% - 83% and 77% - 84% after treated by FY01, which was hold for 50 days at 4℃ and 23 -28℃. The performance on treatment chromium-electroplated wastewater was remarkable. Two columns were used in treating 2000 mL this kind of wastewater in series for 2 hours. The removal rates of Cr,Cu^2＋ and COD were 92. 1% , 99. 2% and 71. 4% , when the initial concentrations were 60. 4 mg/L, 4. 51 mg/L and 48.2 mg/L respectively.
出处
《环境污染治理技术与设备》
CAS
CSCD
北大核心
2006年第1期102-105,共4页
Techniques and Equipment for Environmental Pollution Control
基金
国家自然科学基金资助项目(50278040)
关键词
生物吸附
吸附柱
生物吸附剂
铬
活性污泥
biosorption
adsorption column
biosorbent
chromium
activated sludge
