期刊文献+

双态高铌TiAl合金的蠕变行为 被引量:6

Creep Behavior of a Duplex High-Nb Containing TiAl Alloy
下载PDF
导出
摘要 研究了Ti-45Al-9(Nb,W,B,Y)两相合金分别在760℃和815℃时,应力值在80MPa^300MPa区间的蠕变行为。蠕变前合金的显微组织为均匀细小的双态组织。将研究结果与高铌TiAl合金全片层组织的蠕变性能进行了对比,发现所研究的双态组织合金具有相对较弱的蠕变抗力,其最小蠕变速率较全片层组织Ti46Al8.5Nb0.1C0.2B合金的要高1个数量级。蠕变应力指数表明,该合金在760℃~815℃,80MPa^300MPa的蠕变条件下,合金的蠕变受位错攀移控制。 The creep behavior of a two phase Ti-45Al-9 (Nb,W,B,Y) alloy was investigated at 760℃ and 815℃, under stresses ranging from 80 MPa to 300 MPa. The initial microstructure was found to be fine duplex microstructure. The comparison of the creep properties was presented between,the duplex and the full lamellar microstructure of high-Nb containing TiAl ahoy. It can be confirmed that the duplex alloy studied exhibit lower creep resistance and a minimum creep rate higher than that of the full lamellar Ti46A18.5Nb0.1C0.2B alloy by one order of magnitude. Creep stress exponents show that at 760℃-815℃, 80 MPa-300 MPa, the creep mechanism of this alloy is dislocation climb.
机构地区 北京科技大学
出处 《稀有金属材料与工程》 SCIE EI CAS CSCD 北大核心 2006年第2期257-260,共4页 Rare Metal Materials and Engineering
基金 国家重点基础研究发展规划项目(G2000067206-2) 国家自然科学基金(50274005)联合资助
关键词 蠕变性能 TIAL 最小蠕变速率 creep properties TiAl minimum creep rate
  • 相关文献

参考文献6

二级参考文献24

  • 1W.H. Tian and M. Nemoto2(Department of Materials Physics, University of Science and Technology Beijing, Beijing 100083, China)(Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University, 812,Fukuoka, Japan).PRECIPITATION BEHAVIOUR AND HARDENING OFB2-ORDERED Ni(Al, Ta)[J].Acta Metallurgica Sinica(English Letters),1997,10(2):99-104. 被引量:4
  • 2黄伯云,贺跃辉,曲选辉,雷长明.TiAl基合金热机械处理新工艺技术的研究[J].中南工业大学学报,1995,26(5):632-636. 被引量:17
  • 3郝士明,金属学报,1995年,28卷,4期,B157页
  • 4蒲忠杰,金属学报,1993年,29卷,8期,A366页
  • 5Beddoes J,Structural Intermetallics 1997,1997年,109页
  • 6Chen W R,Acta Metall Sin,1996年,9卷,6期,565页
  • 7张永刚,Acta Metall Sin,1995年,8卷,6期,359页
  • 8Beddoes J,Gamma Titanium Aluminides,1995年,959页
  • 9Wang J N,Gamma Titanium Aluminides,1995年,949页
  • 10Yamanaka T, Johnson D R, Inui H et al. Directional Solidification of TiAl-Re-Si Alloys with Aligned Lamellar Microstructures[J]. Intermetallics, 1997, 7:779-784

共引文献53

同被引文献95

引证文献6

二级引证文献44

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部