摘要
利用1株产碱杆菌DN25作为降氰菌株,以聚氨酯泡沫为载体进行固定化,研究其转化特性.结果表明,采用吸附生长法能有效实现菌株DN25的固定,固定细胞量可达到每g泡沫载体生物量干重0.35g.固定化细胞的最适转化温度和pH为35℃、8.0.对于低浓度氰化物,固定化细胞和游离细胞的转化速率相当;对于高浓度氰化物,固定化细胞具有明显优势,不仅可耐受更高浓度的氰化物转化,其转化速率也高于游离细胞,最大转化速率为507mg/(L.h),是游离细胞的2.8倍.通过初步的摇瓶模拟序列批式反应,固定化细胞活性可保持20d.
An Alcaligenes sp. DN25 strain was immobilized on polyurethane foam and cyanide-biotransformation characteristics of immobilized ceils were investigated. Immobilization could be realized through the growth of the cell on the polyurethane foam and cell load of 0.35g was obtained. The immobilized cell exhibited the best degradation behavior at pH 8.0 and 35℃. For the low concentration cyanide, the degradation rate was the same no matter which the immobilized cell and the free cell were used, while the immobilized cell was proved to be of a more rapid degradation rate for the high-concentration cyanide. The highest cyanidedegradation rate for the immobilized cell could reach 507mg/（L· h）, which was 2.8 times as that of the free cell. Through the preliminary sequencing batch reactor, the immobilized cell could maintain active after 20 days.
出处
《环境科学》
EI
CAS
CSCD
北大核心
2006年第3期586-589,共4页
Environmental Science
基金
国家自然科学基金项目(39860038)
华东理工大学生物反应器工程国家重点实验室开放课题
广西自然科学基金资助项目(桂科青0447003)
关键词
聚氨酯泡沫
固定化细胞
氰化物
生物转化
polyurethane foam
immobilized cell
cyanide
biotransformation
