摘要
通过试验分析比较铣槽深度的改变对中密度纤维板表面结合强度测试结果的影响。试验结果表明,铣槽深度在0.3～0.8mm范围内变化时,对测试结果的影响不大;当铣槽深度在0.3～0.8mm范围以外变化时,则对测试结果有较大的影响。
The influence of changing the milled groove depth on testing results of the surface bonding strength of MDF was analysed through experiment. The result showed that when the groove depth varied from 0.3mm to 0.8mm, it made few differences in the testing results; but when the depth was out of that range, it made big differences.
出处
《中国人造板》
2006年第5期18-20,共3页
China Wood-Based Panels
