摘要
介绍利用PRO/E对齿轮进行建模的具体方法和有关程序,并尝试将齿轮模型导入到ANSYS中进行有限元分析.将CAD软件的强大的建模功能与CAE软件结合起来,扩大了其应用范围,简化了分析过程,并利用其对齿轮的接触应力进行了计算,介绍了算法原理.
The frequency analysis method is used in the field of Fault diagnosis of transmission gearbox of blast furnace top. This paper introduces the concrete method of setting up the parametric-gears mold and the relevant procedure.By the data exchange interface of Pro/E and ANSYS,the analysis of gears＇ contact stress is carried out.
出处
《湖北工业大学学报》
2006年第3期56-59,共4页
Journal of Hubei University of Technology
关键词
齿轮
有限元分析
建模
接触分析
gear
finite element analysis
modeling
contact analysis
