摘要
研究了喷涂电压、喷涂电流、表面预处理、预热、后热处理对电弧喷涂3Cr13钢涂层结合强度的影响.结果表明：电弧喷涂φ2 mm的3Cr13钢丝材的适宜电压、电流为28～35 V、170～180 A;喷砂处理是提高涂层与基体结合强度的最佳表面预处理工艺;采用合适的表面预处理、喷涂打底层、严格控制基体的热量输入是提高涂层结合强度的有效途径.
Effects of different spraying voltage and current, surface pretreatment, pre-heat, and subsequently heat treatment on bonding strength of arc sprayed 3Cr13 steel coating were investigated. The results indicate that the suitable voltage and current are 28 -35 V and 170 - 180 A for arc spraying 3Cr13 steel wire with diameter of 2 mm. Sand blast is the optimum method for surface pretreatment to enhance the bonding strength between coating and matrix. Applying a suitable surface pretreatment, spraying base coating and strictly controlling heat input into the base metal are the effective ways to improve the bonding strength of arc spraying 3Cr13 steel coating.
出处
《金属热处理》
CAS
CSCD
北大核心
2006年第8期18-20,共3页
Heat Treatment of Metals
