期刊文献+

雷达接收机前端的系统设计 被引量:1

Design of System for Receiver's Forepart of Radar
下载PDF
导出
摘要 文中介绍了一种雷达接收机前端的系统设计方法,它选用一种超外差式接收机,采用前端高增益低噪声放大器来减小接收机的噪声系数,再利用混频器将射频信号转变为中频信号,在确定采用自动增益控制接收机后将功率合理分配,以保证接收机有较大的动态范围,提高探测精度。 A method used to design the system of the front-ends in radar receiver is introduced here. The superheterodyne reception is used and a high-gain low noise amplifier in the front-ends is used to reduce the noise figure, also,mixer is used to transmit the RF signal to the medium frequendy signal. Then. the AGC receiver is adopted,after which the power is distributed suitable in order to make sure the receiver have enough dynamic range. At the same time,the detecting precision is advanced.
作者 周亚辉
出处 《弹箭与制导学报》 CSCD 北大核心 2006年第3期262-265,共4页 Journal of Projectiles,Rockets,Missiles and Guidance
关键词 噪声系数 混频器 增益 目标回波 雷达 noise figure mixer gain target echo
  • 相关文献

参考文献2

  • 1丁鹭飞 耿富录.雷达原理[M].西安:西安电子科技大学出版社,1997..
  • 2王小谟 张光义 贺瑞龙 等.雷达与探测[M].北京:国防工业出版社,2000..

共引文献65

同被引文献8

  • 1邹涌泉.一种软件无线电宽带射频前端的设计[J].电讯技术,2007,47(1):68-70. 被引量:8
  • 2余丽.航管应答机的中频数字化设计[J].电讯技术,2007,47(2):100-103. 被引量:4
  • 3Walter Tuttlebee.软件无线电技术与实现[M].北京:电子工业出版社,2004.
  • 4Walke R L , Dudley J. An FPGA Based Digital Radar Receiver for Soft Radar [ J ]. Conference Record of the Asilomar Conference on Signals, Systems and Computers ,2000,1:73 - 77.
  • 5Bada A M,Maddiotto M. Design and Realisation of Digital Radio Transceiver Using Software Radio Architectrue [J]. IEEE Vehicular Technology Conference ,2000,3 : 1727 - 1731.
  • 6Puvaneswari M,Sidek O. Wideband Analog Front-end for Multi -Standard Software Defined Radio Receiver [J]. Personal, Indoor and Mobile Radio Communications,5th IEEE International Symposium ,2004,3:1937 -1941.
  • 7Luy Johann- Frledrich, Thomas Mueller, Torsten Mack. Configurable RF Receiver Architectures[J]. IEEE microwave magazine ,2004, ( 3 ) :75 - 82.
  • 8Altera Corporation. Stratix II Device Handbook [ M]. [ S. L. ] :Altera Corporation ,2006.

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部