摘要
分析了夹壳类零件的冲压工艺和采用级进模生产的可行性及难点,阐述了排样设计方案,介绍了模具结构特点。模具经调整后,加工的零件尺寸精度、外观质量均满足设计要求。
The stamping technique for the shell component and the feasibility and difficulties in aPplying progressive die to manufacture were analyzed. The layout scheme and structural feature of die were described. The precision of component dimensions and appearance quality was in response to the design requirements.
出处
《模具工业》
北大核心
2006年第10期34-38,共5页
Die & Mould Industry
关键词
夹壳类零件
工艺分析
排样
级进模
弯曲模
shell component
technical analysis
stock layout
progressive die
bending die
