摘要
In the conventional multiband orthogonal frequency division multiplexing ultra wideband （MB-OFDM UWB ） receiver, the fast Fourier transform （FFT） algorithm is realized by the expensive and power-consuming digital signal processor （DSP） chips. In this article, the lower power, lower cost, and lower complexity real-time analog surface acoustic wave （SAW） chirp Fourier transform devices were used to replace the DSP part. A MB-OFDM UWB receiver based on the M-C-M SAW chirp Fourier transform was presented, and the step of signal transformation from input signals was also depicted. The simulation results show that the proposed receiver provides similar bit error performance compared to the fully digital receiver when used in the channel environments proposed by the IEEE 802.15SG3a.
In the conventional multiband orthogonal frequency division multiplexing ultra wideband （MB-OFDM UWB ） receiver, the fast Fourier transform （FFT） algorithm is realized by the expensive and power-consuming digital signal processor （DSP） chips. In this article, the lower power, lower cost, and lower complexity real-time analog surface acoustic wave （SAW） chirp Fourier transform devices were used to replace the DSP part. A MB-OFDM UWB receiver based on the M-C-M SAW chirp Fourier transform was presented, and the step of signal transformation from input signals was also depicted. The simulation results show that the proposed receiver provides similar bit error performance compared to the fully digital receiver when used in the channel environments proposed by the IEEE 802.15SG3a.
基金
This study is supported by National Natural Science Foundation of China(60271018)
0pen Fund of Key Lab of 0ptical Communication and Light-wave Technology,(Beijing University of Posts and Telecommunications),Ministry of Education,China.
