摘要
采用一种新颖的水热电沉积方法直接在石墨表面制备了硅酸钇涂层,利用XRD,EDS和SEM等测试手段对涂层进行测试分析,重点研究了电沉积前驱溶液pH值对涂层显微结构的影响。结果表明:当前驱液的pH值为1.5~3.0及水热温度为150℃时,即可制备出硅酸钇涂层。随前驱液pH值增加,涂层开裂趋势减弱,结晶趋势增强,致密度有所提高。
Yttrium silicates coatings were prepared with a novel hydrothermal electrodepostion method on the graphite surface directly. The phases and microstructures of the coatings were characterized by XRD, EDS and SEM analyses. The influence of pH value of the precursor solution on the phase and microstructure was investigated primarily. It showed that the yttrium silicates coatings could be obtained with the pH value in the scope of 1.5 -3.0 at 150℃. With the increase of pH value, micro-cracks and micro-pores of the coatings decrease; and the crystallinity and density of the coatings have been improved correspondingly.
出处
《航空材料学报》
EI
CAS
CSCD
2006年第5期77-80,共4页
Journal of Aeronautical Materials
基金
陕西省自然科学基金(2005E108)
陕西科技大学博士科研基金(BJ05-3)
陕西科技大学研究生创新基金(YC05-3)
关键词
硅酸钇涂层
PH值
显微结构
水热电沉积
石墨
yttrium silicates coating
pH value
mierostrueture
hydrothermal eleetrodepostion
graphite