摘要
从反应注射成型过程对混合器的结构设计、操作条件等的要求出发,对碰撞式混合器的设计和使用应注意的问题进行了分析探讨,并提出了相应的解决办法和处理措施。
On the basis of the demands of the reaction injection molding process for the performance of the impingement mixer, some problems concerning its configurations and operation conditions,to which more attention should be paid during its design and application,were pointed out and analyzed.Some suggestions were also offered to treat these problems.
出处
《合成橡胶工业》
CAS
CSCD
北大核心
1996年第5期265-267,共3页
China Synthetic Rubber Industry
关键词
混合
注塑成型
混合器
塑料
reaction injection molding
mixing
review