摘要
In order to investigate the distribution of Cu and its effect on the microstructure of Cu-bearing steel, a series of mild steels containing different contents of Cu are developed by vacuum electric arc furnace. These steels are annealed at 1 260℃, 1 100 ℃ and 1 000℃ respectively for one hour and followed by furnace cooling to room temperature to simulate the heat treatment before the rolling process. The results show that Cu did not obviously segregate in annealed steels. The scanning electron microscope （SEM） observation show that the main microstruetures in Cu-bearing steel are ferrite and pearlite; The volume fraction of pearlite in steel increase with increasing Cu content. The grain size reduces with the decrease of annealing temperature. The results of energy dispersive X-ray analysis （EDXA） suggest that the Cu content in pearlite is higher than that in ferrite, which means that the microstructure-segregatian of Cu exists. However, the cast specimens show that Cu content in MnS and S-rich phase is very high, and Cu changed the distribution of/vinS in steel. In addition, the optimal Cu content in steel between 0.2%-0.4% and the optimal annealing temperature between 1 100-1 200℃are determined by the economical and practical principles.
In order to investigate the distribution of Cu and its effect on the microstructure of Cu-bearing steel, a series of mild steels containing different contents of Cu are developed by vacuum electric arc furnace. These steels are annealed at 1 260℃, 1 100 ℃ and 1 000℃ respectively for one hour and followed by furnace cooling to room temperature to simulate the heat treatment before the rolling process. The results show that Cu did not obviously segregate in annealed steels. The scanning electron microscope （SEM） observation show that the main microstruetures in Cu-bearing steel are ferrite and pearlite; The volume fraction of pearlite in steel increase with increasing Cu content. The grain size reduces with the decrease of annealing temperature. The results of energy dispersive X-ray analysis （EDXA） suggest that the Cu content in pearlite is higher than that in ferrite, which means that the microstructure-segregatian of Cu exists. However, the cast specimens show that Cu content in MnS and S-rich phase is very high, and Cu changed the distribution of/vinS in steel. In addition, the optimal Cu content in steel between 0.2%-0.4% and the optimal annealing temperature between 1 100-1 200℃are determined by the economical and practical principles.
基金
This project is supported by National Natural Science Foundation of China (No.50499336)National Basic Research Program of China (973 Program, No.2004CB619101).
