期刊文献+

Nd对Mg基块体金属玻璃的玻璃形成能力的影响

The Effect of Nd Addition on the Glass-Forming Ability of Mg-Based Bulk Metallic Glasses
下载PDF
导出
摘要 通过熔体铜型浇注方法制备了Mg65Cu25NdxY10-x(x=4,5,7,10)合金,并对它们的玻璃形成能力进行了研究。利用X射线衍射确定合金的结构组成,差示扫描量热计(DSC)分析合金的玻璃转变、晶化和熔化行为。结果表明:在Mg65Cu25NdxY10-x合金中,当x=5时,合金的非晶形成能力最强,玻璃形成的临界厚度大约为4.5mm,同时非晶的过冷液相区ΔTx和约化玻璃转变温度Trg均为最大,分别为54.5K和0.581。当x≥5时,随着Nd含量的增加,金属玻璃的玻璃转变温度Tg降低,过冷液相区ΔTx减小,约化玻璃转变温度Trg也随之相应地变化。 Mg65Cu25NdxY10-x(x=4, 5, 7, 10)bulk metallic glasses were prepared by a method of melt casting into copper mould in the air and then the effect of Nd on the glass-forming ability of these alloys was studied. The structures of as-cast alloys were analyzed with x-ray diffraction. The glass transition, crystallization and melting behavior of the alloys were investigated using differential scanning calorimetry (DSC). It is indicated that the glass-forming ability of Mg65Cu25Nd5Y5 alloy was the best. Metallic glass strip with a critical thickness of 4.5 mm was obtained, and the supercooled liquid region △Tx is about 54.5 while the reduced glass transition temperature Trg is 0.581. For the alloys with x≥5, the metallic glasses exhibit a reduction of both the glass transition temperature Tg and △ Tx with the increasing x value. There is also a corresponding change of Trg.
出处 《铸造》 EI CAS CSCD 北大核心 2007年第3期294-296,共3页 Foundry
基金 教育部留学回国人员科研启动基金项目(2005年度) 江苏大学高级人才启动基金项目(04JDG018)的资助。
关键词 Mg基金属玻璃 过冷液相区 玻璃形成能力 Mg-based metallic glass supercooled liquid region glass-forming ability
  • 相关文献

参考文献15

  • 1ELDRUP M,SCHRDER Pedersen A,OHNUMA M,et al.Bulk amorphous alloys:preparation andproperties of (Mg0.98Al0.02)x(Cu0.75Y0.25)100-x[J].Mater Sci Forum,2000,(343/346):123-128.
  • 2INOUE A,KAWAMURA Y,MATSUSHITA M,et al.High strength nanocrystalline Mg-based alloys[J].Mater Sci Forum,2002.(386/388):509-518.
  • 3孙琴,陈刚,王宁,李宝贵,张伟.Mg-Cu-Y块体金属玻璃的塑性变形特性[J].热加工工艺,2005,34(4):56-57. 被引量:5
  • 4陈刚,王宁,张伟.Mg_(65)Cu_(25)Y_(10)金属玻璃时效处理的研究[J].热加工工艺,2005,34(10):13-14. 被引量:4
  • 5INOUE A,KATO A,ZHANG T,et al.Mg-Cu-Y amorphous alloys with high mechanical strengths produced by a metallic mold castingmethod[J].MaterTran JIM,1991,32:609-616.
  • 6INOUE A,NAKAMURA T,NSHIYAMA N,et al.Mg-Cu-Ybulk amorphous alloys with high tensile strength produced by a high-pressure die casting method[J].Mater Trans JIM,1992,33:937-45
  • 7BUSCH R,LIU W,JOHNSON W L.Thermodynamics and kinetics of the Mg65Cu25Y10 bulk metallic glass forming liquid[J].Phys J Appl,1998.83:4134.
  • 8KANG H G,PURK E S,et al.Fabrication of bulk Mg-Cu-Ag-Y glassy alloy by squeeze casting[J].Mater Trans JIM,2000,41:846
  • 9AMIYA K,INOUE A.Thermal stability and mechanical property of Mg-Y-Cu-M(M=Ag,Pd)bulk amorphous alloys[J].Mater Trans JIM.2000.41:1460.
  • 10AMIYA K,INOUE A,et al.Preparation of bulk glassy Mg65Y10Cu25Ag5Pd5 alloy of 12 mm in diameter by water quenching[J].Mater Trans,2001.42:543.

二级参考文献22

  • 1Inoue A, Kohinata M, Tasi An-ping, et al. Mg-Ni-La amorphous alloys with a wide supercooled liquid region[J]. Mater .Trans. JIM, 1989, 10: 378-381.
  • 2Gyoo Kim G, Inoue A, Masumoto T. High mechanical strengths of Mg-Ni-Y and Mg-Cu-Y amorphous alloys with significant super cooled liquid region [J]. Mater. Trans. JIM, 1990, 11: 929-934.
  • 3Inoue A. Stabilization of metallic supercooled liquid and bulk amorphous alloys [J]. Acta Materialia, 2000, 48: 279-306.
  • 4Inoue A. Stabilization and high strain-rate superplasticity of metallic supercooled liquid [J]. Materials Science and Engineering, 1999, A267: 171-183.
  • 5Nieh T G, Wadsworth J, Liu C T, et al. Plasticity and structural instability in a bulk metallic glass deformed in the supercooled liquid region [J]. Acta Materialia, 2001, 49: 2887-2896.
  • 6Chu J P, Chiang C L, Nieh T G, et al. Superplasticity in a bulk amorphous Pd-40Ni-20P alloy: a compression study [J]. Intermetallics, 2002, 10: 1191-1195.
  • 7Men H, Kim D H. Fabrication of ternary Mg-Cu-Gd bulk metallic glass with high glass-forming ability under air atmosphere [J]. J Mater Res, 2003, 18: 1502-1504.
  • 8Xi X K, Zhao D Q, Pan M X, et al. Highly processable Mg65Cu25Tb10 bulk metallic glass [J]. Journal of Non-Crystalline Solids, 2004, 344: 189-192.
  • 9Eldrup M, Schr φ der Pedersen A, Ohnuma M, et al. Bulk amorphous alloys: preparation and properties of (Mg0.98Al0.92)x (Cu0.75Y0.25)100-x[J].Mater. Sci. Forum. ,2000,343/346:123-128.
  • 10Inoue A,Kimura H,Amiya K. Develop of aluminum and magnesium-based nanophase high-strengh alloys by use melt quenching-induced metastable phase [J]. Mater. Trans . JIM,2002,43 (8):2006-2016.

共引文献7

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部