期刊文献+

LDPE/MVQ并用胶的组份对其热老化性能的影响 被引量:4

The Effect of the Composition of LDPE/MVQ Hybrid Rubber on its Thermal Ageing Properties
下载PDF
导出
摘要 在室温下实现甲基乙烯基硅橡胶(MVQ)和沉淀法白炭黑(SiO2)的共混,制备出MVQ混炼胶。在150—180℃下实现MVQ混炼胶和低密度聚乙烯(LDPE)的熔融共混,制备出LDPE/MVQ并用胶。研究结果表明,随着SiO2含量的增加,LDPE/MVQ并用胶的耐空气热老化性能下降;羟基硅油对材料的热老化性能影响不明显,但甲基乙烯基硅油可显著改善材料的热老化性能;随着LDPE与MVQ混炼胶的质量比的增加,材料的耐热老化性能下降。 Precipitated silica (SiO2) was incorporated in MVQ by a two roll mill mixer at room temperature to prepare SiO2/ MVQ compound, The compound was then blended with low density polyethylene(LDPE) in the temperature range of 150 ℃ - 180 ℃ to become LDPE/MVQ hybrid rubber. Results of the research showed that the thermal aging resistance of the material decreased with increase in % content of SiO2 in the hybrid rubber and the hydroxyl silicon oil added had only small effect on the thermal aging resistance. But the methyl vinyl silicon oil added may improve thermal aging resistance remarkably. The thermal aging resistance of LDPE/MVQ hybrid rubber decreased with the increase in the mass ratio of LDPE : MVQ.
出处 《电线电缆》 2007年第2期36-37,41,共3页 Wire & Cable
基金 安徽省自然科学基金(50440905) 国家自然科学基金重大项目(10590355)
关键词 低密度聚乙烯 甲基乙烯基硅橡胶 共混 热老化性能 LDPE methyl vinyl silicone rubber blend thermal aging properties
  • 相关文献

参考文献10

  • 1Warrick E L. Crystallinity and orientation in silicone rubber.Ⅰ X-ray studies[J]. Journal of Polymer Science, 1958,27(115) : 1-4.
  • 2Warrick E L. Crystallinity and orientation in silicone rubber. Ⅱ .Physical measurements [ J ]. Journal of Polymer Science, 1958, 27(115) : 19-38.
  • 3Jana P N, Mukunda P G, Nando G B. Thermograviraetric analysis of compatibilized blends of low density polyethylene and poly (dimethyl siloxane) rubber[J]. Polymer Degradation and Stability, 2003,80(1) :75-82.
  • 4付群星.硅橡胶绝缘电线UL安全认证的特点[J].电线电缆,2002(6):24-25. 被引量:1
  • 5王进文.低密度聚乙烯-硅橡胶共混体电缆绝缘材料[J].世界橡胶工业,2006,33(2):18-26. 被引量:6
  • 6Jana R N, Nando G B, Khastgir D. Compatibilised blends of LDPE and PDMS rubber as effective cable insulants[J]. Plastics, Rubber and Composites, 2003,32(1): 11-19.
  • 7Hsien-Tang Chiu, Jyh-Horng Wu. Silicone/polypropylene oxidepolyethylene oxide copolymer/clay composites(Ⅰ)-curing behavior,intermolecular interaction and thermomechanical proporties [ J ].Journal of Polymer Research, 2004,11 (4) : 247-255.
  • 8Quazi R T, Bhattacharya S N, Kosior E. The effect of dispersed paint particles on the mechanical properties of rubber toughened polypropylene composites[ J]. Journal of Materials Science, 1999, 34(3) :607-614.
  • 9Jana R N, Bhunia H P, Nando G B. An investigation into the mechanical properties and curing kinetics of blends of low-density polyethylene and pelydimethyl siloxane rubber [ J ]. Thermochimica Acta, 1997,302(1-2) : 1-9.
  • 10张泽鸿.硅橡胶绝缘耐火电缆的开发与研究[J].电线电缆,2005(3):10-13. 被引量:8

二级参考文献1

  • 1R.N.Jana,G.B.Nando,D.Khastgir.Compatibilised blends of LDPE and PDMS rubber as effective cable insulants[J].Plastics,Rubber and Composites,2003,32(1):11-19.

共引文献12

同被引文献45

引证文献4

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部